690911

Makita EA3601F Manual

6
Zoom out
Zoom in
Previous page
1/54
Next page
6
• For cutting down trees or performing crosscuts the spike bumper (Z) must
be applied to the wood to be cut.
• Before performing a crosscut rmly apply the spike bumper to the timber, only
then can the timber be cut with the chain running. For this the chain saw is lifted
at the rear handle and guided with the front handle. The spike bumper serves
as a centre of rotation. Continue by slightly pressing down the front handle and
simultaneously pulling back the chain saw. Apply the spike bumper a little bit
deeper and once again lift the rear handle.
• When the timber must be pierced for cutting or longitudinal cuts are to be
performed it is urgently recommended to have this carried out by specially
trained persons only (high risk of kickback).
• Do longitudinal - lengthwise - cuts at the lowest possible angle. Be very careful
when doing this type of cut, as the spike bumper cannot grip.
• The saw must be running whenever you remove the chain saw from the wood.
• When performing several cuts the throttle trigger must be released in between.
• Be careful when cutting splintery wood. Cut pieces of wood may be pulled along
(risk of injuries).
• When cutting with the upper edge of the guide bar, the chain saw may be pushed
in the direction of the user if the chain gets clamped. For this reason use the
lower edge of the bar whenever possible. The chain saw will then be pushed
away from you.
• If the timber is under tension, rst cut the pressure side (A). Then the crosscut
can be performed on the tension side (B). Thus clamping of the guide bar can be
avoided.
CAUTION:
People felling trees or cutting of branches must be specially trained. High risk
of injuries!
• When cutting of branches, the chain saw should be supported on the trunk. Do
not use the end of the bar for cutting (risk of kickback).
• Be aware of branches under tension. Do not cut free branches from below.
• Never perform detensioning cuts while standing on the trunk.
B
A
B
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Makita EA3601F at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Makita EA3601F in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Turkish, Spanish as an attachment in your email.

The manual is 12,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info