Manual Makita DFL651F (page 5 of 64) (English, German, Dutch, Danish, French, Italian, Portuguese, Turkish, Spanish)

691709

Zoom out

Zoom in

1/64

WARNING:

DO NOT let comfort or familiarity with product

(gained from repeated use) replace strict adherence

to safety rules for the subject product. MISUSE

or failure to follow the safety rules stated in this

instruction manual may cause serious personal

injury.

ENC007-10

IMPORTANT SAFETY INSTRUCTIONS

FOR BATTERY CARTRIDGE

1. Before using battery cartridge, read all

instructions and cautionary markings on (1)

battery charger, (2) battery, and (3) product

using battery.

2. Do not disassemble battery cartridge.

3. If operating time has become excessively

shorter, stop operating immediately. It may

result in a risk of overheating, possible burns

and even an explosion.

4. If electrolyte gets into your eyes, rinse them out

with clear water and seek medical attention right

away. It may result in loss of your eyesight.

5. Do not short the battery cartridge:

(1) Do not touch the terminals with any

conductive material.

(2) Avoid storing battery cartridge in a

container with other metal objects such as

nails, coins, etc.

(3) Do not expose battery cartridge to water or

rain.

A battery short can cause a large current

ow, overheating, possible burns and even a

breakdown.

6. Do not store the tool and battery cartridge in

locations where the temperature may reach or

exceed 50°C (122°F).

7. Do not incinerate the battery cartridge even if it

is severely damaged or is completely worn out.

The battery cartridge can explode in a re.

8. Be careful not to drop or strike battery.

9. Do not use a damaged battery.

10. Follow your local regulations relating to

disposal of battery.

SAVE THESE INSTRUCTIONS.

CAUTION: Only use genuine Makita batteries.

Use of non-genuine Makita batteries, or batteries that

have been altered, may result in the battery bursting

causing res, personal injury and damage. It will

also void the Makita warranty for the Makita tool and

charger.

Tips for maintaining maximum battery life

1. Charge the battery cartridge before completely

discharged.

Always stop tool operation and charge the

battery cartridge when you notice less tool

power.

2. Never recharge a fully charged battery cartridge.

Overcharging shortens the battery service life.

3. Charge the battery cartridge with room

temperature at 10°C – 40°C (50°F – 104°F). Let a

hot battery cartridge cool down before charging

it.

4. Charge the battery cartridge if you do not use it

for a long period (more than six months).

FUNCTIONAL DESCRIPTION

CAUTION:

• Always be sure that the tool is switched off and the

battery cartridge is removed before adjusting or

checkingfunctiononthetool.

Installing or removing battery cartridge (Fig. 1)

CAUTION:

• Alwaysswitchoffthetoolbeforeinstallingorremoving

ofthebatterycartridge.

• Hold the tool and the battery cartridge rmly when

installing or removing battery cartridge. Failure to

holdthetoolandthebatterycartridgermlymaycause

themtoslipoffyourhandsandresultindamagetothe

toolandbatterycartridgeandapersonalinjury.

Toremovethebatterycartridge,slideitfromthetoolwhile

slidingthebuttononthefrontofthecartridge.

To install the battery cartridge, align the tongue on the

batterycartridgewiththegrooveinthehousingandslip

itintoplace.Insertitallthewayuntilitlocksinplacewith

alittleclick.Ifyoucanseetheredindicatorontheupper

sideofthebutton,itisnotlockedcompletely.

CAUTION:

• Always install the battery cartridge fully until the red

indicatorcannotbeseen.Ifnot,itmayaccidentallyfall

outofthetool,causinginjurytoyouorsomeonearound

you.

• Do not install the battery cartridge forcibly. If the

cartridgedoesnotslideineasily,itisnotbeinginserted

correctly.

Battery protection system

The tool is equipped with a battery protection system.

Thissystemautomaticallycutsoffpowertothemotorto

extendbatterylife.

The tool will automatically stop during operation if the

tooland/orbatteryareplacedunderoneofthefollowing

conditions:

• Overloaded:

The tool is operated in a manner that causes it to

drawanabnormallyhighcurrent.

In this situation, turn the tool off and stop the

application that caused the tool to become

overloaded.Thenturnthetoolontorestart.

Ifthetooldoesnotstart,thebatteryisoverheated.

In this situation, let the battery cool before turning

thetoolonagain.

• Lowbatteryvoltage:

The remaining battery capacity is too low and the

tool will not operate. In this situation, remove and

rechargethebattery.

NOTE:

• The overheat protection works only with a battery

cartridgewithastarmarking.(Fig. 2)

Indicating the remaining battery capacity

(Fig. 3)

(Only for battery cartridges with “B” at the end of the

modelnumber.)

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Makita DFL651F in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Turkish, Spanish as an attachment in your email.

The manual is 1,78 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Makita DFL651F Manual

Product: