600558

Makita DCM500 Manual

7
Zoom out
Zoom in
Previous page
1/60
Next page
7
OPERATION
PARTS IDENTIFICATION (Fig. C)
Button
Red indicator
Battery cartridge
Star marking
Tank lid
Water tank
Filter
Filter holder
Cup rest (for up to 88 mm tall cups or mugs)
Power switch
Bottom plate
AC power socket
DC power socket
Measure (a level scoop of coffee: 6.5 g)
Battery holder
AC power cord
“LIMIT” island
Overowopening
PREPARATION
Whenusingtheappliancersttime,orafterlongperiodof
storage, perform the following steps:
Remove all packing materials from the appliance.
Cleantheapplianceexteriorandwashthelterand
lterholder(refertotheCLEANINGsection).
Toclearanyresiduefromtheappliance,pour150ml
of fresh water into the water tank and brew (refer to
theBREWINGsection)withoutgroundcoffeeinthe
lteruntilthewatertankisempty.Repeatthesame
operation at least twice.
USE WITH AC POWER (Fig. D)
Plug the AC power cord into the AC power socket on the
appliance, and then into the AC outlet.
NOTE
Do not plug both the AC power cord and battery holder
into the sockets on the appliance at the same time.
A short power-supply cord is provided to reduce risks
resulting from becoming entangled in or tripping over a
longer cord. If you use longer detachable power-supply
cords or extension cords:
Use longer detachable power-supply cords or
extension cords with care.
Use detachable power-supply cord or extension cord
marked with an electrical rating at least as great as
the electrical rating of the appliance.
Use grounding type 3-wire cord only.
Arrange the longer cord so that it will not drape over
the counter top or table top where it can be pulled on
by children or tripped over.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
1.
2.
3.
•
•
-
-
-
-
USE WITH BATTERY
Installing or removing battery cartridge (Fig. A)
CAUTION
Always switch off the appliance before installing or
removing of the battery cartridge.
Hold the battery holder and the battery cartridge
rmly when installing or removing battery cartridge.
Failure to hold the battery holder and the battery
cartridgermlymaycausethemtoslipoffyourhands
and result in damage to the appliance and battery
cartridge and a personal injury.
To remove the battery cartridge, slide it from the battery
holder while sliding the button (Fig. A-1) on the front of
the cartridge.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip it
into place. Insert it all the way until it locks in place with a
little click. If you can see the red indicator (Fig. A-2) on the
upper side of the button, it is not locked completely.
CAUTION
Always install the battery cartridge fully until the red
indicator (Fig. A-2) cannot be seen. If not, it may
accidentally fall out of the battery holder, causing injury
to you or someone around you.
Do not install the battery cartridge forcibly. If the
cartridge does not slide in easily, it is not being inserted
correctly.
Battery protection system
The appliance is equipped with a battery protection
system. This system automatically cuts off power to the
appliance to extend battery life.
The appliance will automatically stop during operation if
the appliance and/or battery are placed under one of the
following conditions:
Overheated:
If the appliance does not start, the battery is
overheated. In this situation, let the battery cool
before pressing the power switch again.
Low battery voltage:
The remaining battery capacity is too low and the
appliance will not operate. In this situation, remove
and recharge the battery.
NOTE
The overheat protection works only with a battery
cartridge with a star mark (Fig. B-4).
Connecting the battery holder (Fig. E)
Plug the battery holder into the DC power socket on the
appliance.
NOTE
Do not plug both the AC power cord and battery holder
into the sockets on the appliance at the same time.
•
•
•
•
•
•
•
•
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Makita DCM500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Makita DCM500 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Turkish, Spanish as an attachment in your email.

The manual is 1,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info