600575
8
Zoom out
Zoom in
Previous page
1/36
Next page
8
NOTE:
The battery charger is for charging Makita-battery cartridge. Never use it for other purposes or for other manufacturer’s batteries.
When you charge a battery cartridge which is new or has not been used for a long period of time, it may not accept a full charge until
after discharging it completely and recharging a couple of times. (Ni-MH battery only)
If you charge a battery cartridge from a just-operated tool or battery cartridge which has been left in a location exposed to direct sunlight
for a long time, the charging light may flash in red color. If this occurs, wait for a while. Charging will begin after the battery cartridge is
cooled by the cooling fan installed in the charger or the charger is cooled.
When charging the battery cartridge with a hot charger, the charging lamp may flash in red. After the charger is cooled, charging starts.
If the charging light flashes alternately in green and red color, or flashes in green color when the battery cartridge is inserted, a problem
exists and charging is not possible. The terminals on the charger are clogged with dust or the Makita battery cartridge is worn out or the
battery of automobile is out of order.
When the battery of automobile works out of order, the charge lamp does not light on even if the charger is plugged into the automobile
cigarette lighter socket.
When the remaining automobile battery capacity gets small, stumble down acceleration pedal and charge the battery cartridge while
stumbling down. After completion of charging, be sure to unplug the charger from the automobile socket.
When charging some battery cartridges successively, the charging time may get longer.
Cooling system
This charger is equipped with cooling fan for heated battery in order to enable the battery to prove its own performance. Sound of
cooling air comes out during cooling, which means no trouble on the charger.
Yellow light will flash for warning in the following cases.
Trouble on cooling fan
Incomplete cool down of battery, such as, being clogged with dust
The battery can be charged in spite of the yellow warning light. But the charging time will be longer than usual in this case.
Check the sound of cooling fan, vent on the charger, which can be sometime clogged with dust.
The cooling system is in order although no sound of cooling fan comes out, if the yellow warning light will not flash.
Always keep clean the vent on charger and battery for cooling.
The products should be sent to repair or maintenance, if the yellow warning light will frequently flash.
Conditioning charge
Conditioning charge can extend the life of battery by automatically searching the optimum charging condition for the batteries in every sit-
uation.
The battery employed in the following conditions repeatedly requires “conditioning charge” to prevent fast wear out. In that case, yellow
light lights up.
1. Recharge of battery with its high temperature
2. Recharge of battery with its low temperature
3. Recharge of full charged battery
4. Over-discharge of battery (continue to discharge battery in spite of down of power.)
The charging time of such battery is longer than usual.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Makita DC18SE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Makita DC18SE in the language / languages: All languages as an attachment in your email.

The manual is 0,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info