600584
3
Zoom out
Zoom in
Previous page
1/16
Next page
3
ENGLISH
CAUTION:
1. SAVE THESE INSTRUCTIONS – This manual contains important safety and operating instructions for battery charger.
2. Before using battery charger, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) prod-
uct using battery.
3. CAUTION – To reduce risk of injury, charge only MAKITA rechargeable batteries. Other types of batteries may burst causing
personal injury and damage.
4. Non-rechargeable batteries cannot be charged with this battery charger.
5. Use a power source with the voltage specified on the nameplate of the charger.
6. Do not charge the battery cartridge in presence of flammable liquids or gases.
7. Do not expose charger to rain or snow.
8. Never carry charger by cord or yank it to disconnect from receptacle.
9. After charging or before attempting any maintenance or cleaning, unplug the charger from the power source. Pull by plug
rather than cord whenever disconnecting charger.
10. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.
11. Do not operate charger with damaged cord or plug – replace them immediately.
12. Do not operate or disassemble charger if it has received a sharp blow, been dropped, or otherwise damaged in any way;
take it to a qualified serviceman. Incorrect use or reassembly may result in a risk of electric shock or fire.
13. The battery charger is not intended for use by young children or infirm persons without supervision.
14. Young children should be supervised to ensure that they do not play with the battery charger.
15. Do not charge battery cartridge when temperature is BELOW 10°C (50°F) or ABOVE 40°C (104°F).
16. Do not attempt to use a step-up transformer, an engine generator or DC power receptacle.
Charging
1. Plug the battery charger into the proper AC voltage source. The charging light will flash in green color.
2. Insert the battery cartridge so that the plus and minus terminals on the battery cartridge are on the same sides as their
respective markings on the charger.
3. When the battery cartridge is inserted fully, the charging light will change from green to red and charging will begin. The
charging light will remain lit steadily during charging.
4. When the charging light changes from red to green, the charging cycle is complete.
5. After charging, unplug the charger from the power source.
Refer to the table for the charging time below.
(Note)*1...18 V batteries can be charged with the charger DC1804 only.
NOTE:
The battery charger is for charging Makita battery cartridge. Never use it for other purposes or for other manufacturer’s batter-
ies.
When you charge a battery cartridge which is new or has not been used for a long period of time, it may not accept a full
charge until after discharging it completely and recharging a couple of times.
If you charge a battery cartridge from a just operated tool or a battery cartridge which has been exposed to direct sunlight or
heat for a long time, the charging light may flash in red color. If this occurs, wait for a while. Charging will begin after the bat-
tery cartridge cools.
If the charging light flashes alternately in green and red, charging is not possible. The terminals on the charger or battery car-
tridge are clogged with dust or the battery cartridge is worn out or damaged.
Trickle charge (Maintenance charge)
If you leave the battery cartridge in the charger to prevent spontaneous discharging after full charge, the charger will switch into
its “trickle charge (maintenance charge)” mode and keep the battery cartridge fresh and fully charged.
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by a Makita
Authorized Service Centers, always using Makita replacement parts.
EC-DECLARATION OF CONFORMITY
ENH005-1
We declare under our sole responsibility that this product is in
compliance with the following standards of standardized doc-
uments, EN60335, EN55014, EN61000 in accordance with
Council Directives, 73/23/EEC and 89/336/EEC.
Yasuhiko Kanzaki
CE 2003
Director
MAKITA INTERNATIONAL EUROPE LTD.
Michigan Drive, Tongwell, Milton Keynes,
Bucks MK15 8JD, ENGLAND
Battery
type
Voltage 7.2 V 9.6 V 12 V 14.4 V 18 V *1
Capacity
(Ah)
Charging
time
(minutes)
Number
of cells
6 8 10 12 15
Ni-Cd battery
cartridge
7000, 7100 9000, 9100/A, 9120 1200/A, 1210, 1220 1420 1.3 30
7001 9001, 9101/A 1201/A 1.7 40
7002 9002, 9102/A, 9122 1202/A, 1222 1422 1822 2.0 45
Ni-MH battery
cartridge
7033 9033, 9133 1233 1433 1833 2.2 50
7034 9034, 9134 1234 1434 1834 2.6 60
9135/A 1235/A/F 1435/F 1835/F 3.0 70
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Makita DC1804 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Makita DC1804 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 0,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info