600592

Makita DBM230 Manual

27
Zoom out
Zoom in
Previous page
1/82
Next page
26
After you have finished drilling:
! Remove the drill bit from the borehole.
! Switch the motor off. Use the motor switch and not the GFCI for this
purpose.
! Close the water supply.
Removal of the bore core, in case it is stuck in the drill bit.
! Remove the drill bit from the motor.
! Put the drill bit in an vertical position.
! Slightly tap with the wooden handle of a hammer against the tube until
the bore core slides out. Never knock the drill bit forcefully against a wall
or treat it with tools like hammers or wrenches, the tube may become
deformed so that neither the bore core will loosen nor the drill bit may be
used again.
Removal of the bore core in a blind hole
Break off the core with a wedge or a lever. Remove the core with suitable pliers
or drill a hole into the core, insert a lifting screw and pull the core out.
Before doing any work on the machine, pull the mains plug!
Repairs may only be performed by qualified, trained and experienced personnel.
After each repair the tool must be inspected by an electrical specialist.
Due to its design, the tool needs only a minimum of care and maintenance.
Nevertheless the following rules should be observed:
! Clean the core drill unit after finishing the drilling. Afterwards grease the
thread of the drill spindle. The air vents must always be open and clean.
Take care that while cleaning the tool no water enters into the core drill
tool.
! After the first 150 operating hours the transmission oil must be
exchanged. The oil exchange will greatly increase the life cycle of the
transmission.
! After approx. 200 operating hours the carbon brushes must be inspected
by an electrical specialist and replaced if necessary (only use original
carbon brushes).
Switches, cable and plug must be inspected regularly by an electrical specialist.
Maintenance and Care
After drilling
… 27 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Makita DBM230 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Makita DBM230 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 1,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info