598435
11
Zoom out
Zoom in
Previous page
1/24
Next page
11
Installing the trimmer head
(BCM2310, BCM2610, BCM3310)
Always switch off the engine and
disconnect the spark plug cap
before mounting the trimmer head!
C
- Remove oating disc (C/6) and thrust washer (C/5).
- Insert the offset screwdriver 4 mm (C/1) through the wind-
ing guard and the locking disc into the opening (C/3) in the
angular gear (block the winding gear). If necessary turn the
mounting disc (C/3) slightly.
- Position the blade (C/4), thrust washer (C/5) and nally the
oating disc (C/6) as shown.
- Screw down the locknut (C/7) and tighten it by turning the
combination wrench counter-clockwise.
Caution: For safety reasons, after every 10 tool changes
the locknut (C/7) must be replaced with a new one. For the
order number, see the spare parts list at the end of this
manual.
- Remove Allen key and check for freedom of motion of the
cutting tool.
D
Mounting the 4-tooth star blade
(BCM2600, BCM3300, BCM4300)
Always switch off the engine and disconnect the spark plug
cap before mounting metal cutter blades! Wear protective
gloves!
- Place the mounting disc (D/3) on the shaft.
- Insert the 4 mm Allen key (D/1) through the winding guard
and the mounting disc (D/3) into the opening on the angle
gear (blocks the angle gear). If necessary turn the mounting
disc (D/3) slightly.
- Screw the trimmer head (D/2) onto the shaft by turning it
counter-clockwise.
- Now tighten the trimmer head by hand.
- Remove the Allen key and check for freedom of motion of
the trimmer head.
- Unscrew the locknut (C/7) from the shaft by turning it clock-
wise. If necessary, block the angle gear (see below).
Note: The locknut is provided with a left-hand thread!
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Makita BCM3310 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Makita BCM3310 in the language / languages: English as an attachment in your email.

The manual is 1,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info