75890

Makita 447 L Manual

14
Zoom out
Zoom in
Previous page
1/100
Next page
10
english
MAKITA 447 L
7.2.3 Replacing filter element
1. Open the retaining clamps
and remove the upper
section of the cleaner from
the dirt tank. Lay the upper
section of the cleaner down
with the filter element facing
upwards. Do not place the
upper section of the cleaner
on the guard (1) and do not
damage the filter element.
2. Open the bar handle (2) and
remove it.
3. Remove the filter holder (3).
4. Carefully remove the filter el-
ement.
5. Clean the filter seal (4).
Check it for damage and
replace it if necessary.
6. Check the antistatic clamp
(5) for damage and have it
replaced by Makita Service
if necessary.
7. Check that the control flap
(6) for filter cleaning works
properly. The control flap
should move back and for-
wards easily.
8. Clean the level hose (7).
9. Fit a new filter element.
10.Fit the filter holder. Ensure
that it is in the correct posi-
tion.
11.Fit bar and close bar handle.
12.Dispose of the used filter
element in accordance with
legal regulations.
CAUTION:
Never use the vacuum cleaner
without a filter.
During the following work,
ensure that dust is not un-
necessarily spread around.
Wear a P2 breathing mask.
4
aut
o
5
1
3
2
6
7
8 Troubleshooting
Fault
‡ Motor does not start > Fuse in mains plug has
blown.
> Overload protection switch
has tripped.
• Reset the fuse.
• Switch off the vacuum clean-
er and allow it to cool for
approx. 5 minutes. If it can
not be started again, contact
the Makita service department.
‡ Motor does not run in auto-
matic mode
> Power tool is defective or not
connected properly.
• Check that the power tool
works or that the plug is
inserted correctly.
Cause
Remedy
… 14 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Makita 447 L at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Makita 447 L in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 4,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info