534676
35
Zoom out
Zoom in
Previous page
1/47
Next page
35
une différente. Souvenez-vous que certains objets peuvent être difficiles à
numériser quel que soit le réglage.
4. Si votre objet est bien placé et que l’éclairage est adéquat, mais que vos
numérisations sont toujours médiocres, vous pourriez devoir étalonner à
nouveau les lasers et la plaque tournante. Nettoyez le filtre de la caméra en
suivant les indications fournies à la page 36 et exécutez les routines
d’étalonnage de la caméra, de la plaque tournante et des lasers à partir du
menu Scanner.
PROBLÈME:
Vous recevez un message « Échec de la numérisation »
SOLUTION:
Cela signifie que MakerWare for Digitizer ne reçoit aucune donnée. Si votre
objet respecte les indications énumérées à la page 9, il peut y avoir un
problème au niveau de la connexion entre votre numériseur MakerBot Digitizer
et votre ordinateur. Suivez les indications concernant la résolution des
problèmes de connexion fournies à la page 33.
35


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for MakerBot Digitizer at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of MakerBot Digitizer in the language / languages: French as an attachment in your email.

The manual is 0,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of MakerBot Digitizer

MakerBot Digitizer User Manual - English - 74 pages

MakerBot Digitizer User Manual - Dutch - 74 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info