637878
21
Zoom out
Zoom in
Previous page
1/34
Next page
PROBLEM
ACTION TO TAKE
AUGER IS
NOT
TURNING
?
?
?
?
?
The auger works on a timed interval basis depending on
the temperature setting of the controller. During start-up,
the auger will run for approximately 2 minutes. It will then
shut off for four minutes, then continue to run again.
Empty the pellet hopper to see if your pellets have been
exposed to moisture. If they have absorbed moisture or
water, they will swell and jam your auger.
Check to make sure that no foreign objects have fallen into
the pellet hopper (like dirt or rocks). Remove any foreign
objects if necessary.
If the pellets have jammed your auger, you will need to
remove the auger and clean out both the auger and auger
tube. This can be done by removing all of the pellets from
the hopper and removing the firepot. Use a shop-vac to
suck out as many pellets from each end of the auger
tube. Remove the fan/access panel, fan and fan deflector.
Unplug the auger from the back of the Pellet Boss®, it is
labeled AUGER. (the white plug receptacle). Remove the
(2) two auger mounting screws from the rear of the motor
and pull the auger motor out through the back of the grill.
Clean out any remaining wet pellets or dust from the auger,
auger tube and surrounding areas. Replace auger in
reverse order and test to see if auger turns before adding
new pellets to the hopper.
Never put spilled pellets from the ground back into
your pellet hopper.
?
?
?
The fan should operate any time the power is turned on. If
the fan is not running, unplug the power cord, remove the
fan/access panel to get to the back of the control board.
Make sure that the plug labeled FAN is tightly plugged into
the BLUE receptacle on the back of the Pellet Boss®
control board.
Check fan blades for any obstruction such as pellets or dirt.
Clean as necessary.
Check the fuse on the back of the Pellet Boss® to make
sure it has not blown. If necessary, replace with 2.0 AMP
Fast Blow fuse of the same size and diameter.
FAN DOES
NOT RUN
21
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for MAK GRILLS EP-380-1G - Pellet BBQ Smoker-Grill at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of MAK GRILLS EP-380-1G - Pellet BBQ Smoker-Grill in the language / languages: English as an attachment in your email.

The manual is 2,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info