581732
8
Zoom out
Zoom in
Previous page
1/52
Next page
8
Dear MAGNAT Customer,
The ANNIVERSARY 4000 STARK car hifi power amplifier will enable you to satisfy your high demands on sound reproduction in your car.
With its impressive deep-bass power reserves, low harmonic content and neutral reproduction, the ANNIVERSARY 4000 STARK takes car
hi-fi to new heights. The amplifier is characterized by low operating current, rapid switching capabilities and excellent temperature stability.
Increased output power can be achieved by switching two amplifier channels in an amplifier together in bridging mode. Experience and
enjoy how this high-tech machine perfectly reproduces magnificent sound.
Please read all of the owner’s manual before installing and using the amplifier.
1. TECHNICAL DATA
Stereo / Bridged
Max. output power (1 kHz sinus burst 2:8, B+=14.4V) 4 x 400 W / 2 x 1200 W on 4 Ohm
Nominal output power (DIN 45 324, B+=14.4V) 4 x 150 W / 2 x 480 W on 4 Ohm
Max. output power (1 kHz sinus burst 2:8, B+=14.4V) 4 x 600 W on 2 Ohm
Nominal output power (DIN 45 324, B+=14.4V) 4 x 240 W on 2 Ohm
Loudspeaker impedance (stereo mode) 2 – 8 Ohm
Frequency response 5 – 75 000 Hz (-3 dB)
Total harmonic content (DIN 45 403) < 0.025% (1 kHz)
Stereo separation (IEC 581 ) > 65 dB (1 kHz)
Weighted noise distance (IEC A) > 100 dB
Input sensitivity LOW LEVEL INPUT 0.2 – 6 V
Input impedance LOW LEVEL INPUT 20 kOhm
Low-pass filter 30 – 150 Hz, 12 dB per octave
High-pass filter 10 – 300 Hz, 12 dB per octave
Bass boost 0 – 12 dB at 45 Hz
Supply +12 V (10 – 15 V), minus to ground
Fuse 100 A Maxifuse
Sizes (W x H x D) 504 x 55 x 230 mm
Weight 5.6 kg
SUBJECT TO TECHNICAL CHANGE
2. FEATURES
· Complementary push-pull final stage
· Stable at 2 ohms
· Infinitely adjustable high-pass filter
· Infinitely adjustable low-pass filter
· Infinitely variable bass equalisation
· Bridgeable 4-/3-/2-channel mode
· Electronic protective circuit against short circuiting, DC offset and excess temperature
· Mute switch for suppressing switch-on crackle interference
· Capsulated and gilded loudspeaker and power-supply screw terminals
· Status indicator (green LED) and overload indicator (red LED)
· Remote control for regulating the volume of the rear channels (CH3 / CH4) (subwoofer operation)
3. IMPORTANT INSTALLATION INFORMATION
· This appliance may only be connected to a 12 volt system with negative ground.
· The heat radiated when the amplifier is used means that sufficient air circulation is required at the place of installation. It is very
important that the cooler’s cooler ribs do not contact any metal plating or any surfaces which could impair air circulation. The amplifier
may not be installed in small confined spaces or spaces without air circulation (e.g. spare wheel recess or under the vehicle carpeting).
Installation in the boot is recommended.
· Install the amplifier in such a way that it is protected as far as possible against vibrations and dust and dirt.
· Make sure that the input/output cables are sufficiently distant from the power supply cables as otherwise interference may occur.
· Make sure that the fuse and operating elements are accessible after installation.
· The appliance’s reliability and performance depend on the quality of installation. Preferably get an expert to install the system,
particularly if you want to install several loudspeakers or a complex multi-way system.
4. CONNECTIONS
4.1 POWER SUPPLY AND AUTOMATIC SWITCHING ON
Important notice: Before commencing the installation, disconnect the plus terminals from the car battery in order to prevent
short circuits.
The power cabling usually installed in on-board car networks is not sufficient for a power amplifier’s demands. Make sure that the power
lines to GND and to the +12 V terminal have been sufficiently specified. A cable cross-section of at least 25 mm² must be used to connect
the battery to the amplifier’s terminals.
First connect the amplifier’s GND terminal to the battery’s minus pole. It is very important that the connection is good. Dirt residues must
be carefully removed from the battery’s connection point. A loose connection may cause malfunctions or interference noise or distortion.
The +12 V amplifier connection must then be connected with a power cable possessing an integrated fuse to the battery’s plus pole. The
fuse must be located close to the battery, the length of cable from the battery’s positive pole to the fuse must be less than 60 centimetres
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Magnat Anniversary 4000 STARK at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Magnat Anniversary 4000 STARK in the language / languages: English, German, Dutch, French, Italian, Portuguese, Swedish, Spanish as an attachment in your email.

The manual is 1,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info