487451

Magic MGC HC 2 R Manual

12
Zoom out
Zoom in
Previous page
1/48
Next page
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity.
12 MGC HC 2 R - 080609
Assembly page 12/48
Fax +32 2 359 95 50
Short cuts
Always cut from the back of the neck to the crown, with the 6 mm comb attachment. Holding
it flat against the head, slowly move the clipper up through the hair. Use the same technique
for the sides, cutting from the bottom to the upper side of the head (14).
For the front of the crown, cut the hair against the direction in which it grows. Then even it up
with the sides (15).
To taper hair down to the neckline, use the 4 mm attachment comb. Comb hair, check for
uneven spots and outline sideburns and neckline. (16)
CUTTING WITHOUT THE COMB ATTACHMENT
To cut the hair with the help of a comb or your fingers as well as to cut the outlines, you do not
need the comb attachment.
Take off the comb attachment by pulling it holding it by the sides.
Cutting hair with the help of a comb or your fingers
Remove the comb attachment carefully, as explained in the previous paragraph.
Raise a wisp of hair with the help of the comb (17), or take the wisp between your fingers (18).
Take the wisp through the comb or fingers until only the desired hair length remains under the
comb/fingers. Cut the hair that is above the comb or fingers with the hair clipper (19 and 20).
Outlining
Outlining requires no attachments, apply directly the blades on the hair.
Comb hair into the required style. Position clipper between the sideburns and the ear. Make
sure the outer edge of the blade is against the hairline. With the outline of the hair as your
guide, slowly move the clipper around the ears (11). For the back of the neck and the
sideburns, hold the clipper upside down (13), and move downwards holding it against the
skin at the length desired. If necessary, insist on thicker hair.
After you acquired a certain experience, you’ll be able to do layered cuts simply by
changing the haircut height according to the part of the head but this manipulation
requires a certain skill to obtain a good result.
MAINTENANCE
Your clipper was carefully examined before leaving our factory to ensure that the blades
were oiled and aligned. To maintain your clipper in peak condition, the blades should be
oiled every few haircuts.
Remove the blades as indicated on page 2 “A1”.
Use the small brush to remove remaining hair.
Lubricate the blades as indicated on page 2 “A2”.
Put the blades back in place as indicated on page 2 “A3”.
Change the blades as soon as they become blunt.
DISPOSAL OF BATTERY
When you decide to throw out your appliance, first remove the battery in order to protect the
environment.
The appliance has to be disconnected from the power supply when you remove the
battery.
Remove the blades as indicated on page 2 “A1”.
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Magic MGC HC 2 R at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Magic MGC HC 2 R in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 0,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info