494095
7
Zoom out
Zoom in
Previous page
1/26
Next page
7
CONTROLS AND INDICATORS
1 • RCA input connectors: To connect the Pre output leads of the main unit to the amplifier
input. These inputs control the final stages.
2 • Adjustment of the gain of the Input: Adjusts input sensitivity of amplifier,
which can vary between 200 mV and 4V.
To adjust sensitivity, proceed as follows:
a)Set the volume control of your unit to 3/4 of its maximum output
b)Adjust the amplifier input gain controls until the maximum possible acoustic
pressure has been obtained without any distortion.
3 • Stereo/Mono switch: changes the output mode of the amplifier between
Stereo and Mono. If Mono is selected, the corresponding Left (mono) input is
used to operate the amplifier.
4 • Crossover switch: selects the output mode of the amplifier by activating the Low-pass or
High-pass filter.
a)Flat: the amplifier will reproduce the complete audio
range in relation to the signal applied to the input.
b)Low-pass: activation of the low-pass filter, i.e.
determination of the finishing-point of the low frequencies
present at the outputs .
c)High-pass: activation of the low-pass filter, i.e.
determination of the starting-point of the high frequencies
present at the outputs.
5 • Continuous adjustment/control of the Low-Pass or High-Pass
frequencies: once the low-pass or high-pass filter is inserted, the crossover
frequency can be adjusted in continuous mode between 30 Hz and 600 Hz.
STL(mono)
30
600
Hz
35
40
50
60
80
125
300
Flat Low High
20Hz 20kHz
Flat Low High
20Hz 30 > 600Hz
Flat Low High
20kHz30 > 600Hz
O/M SP 2.050x 25/06/02 17:44 Page 7
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Macrom SP 2.050 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Macrom SP 2.050 in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 0,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info