782325
25
Zoom out
Zoom in
Previous page
1/60
Next page
32
32
11
32
11
11
31
2930
Fig. 4a
Fig. 4b
To assemble the front rail & rip fence
> Push the five hex bolts M6 x 16 [32] onto the slot of the front rail [11] from the
side of the front rail in turns.
> Insert the hex bolts M6 x 16 [32] through the holes on the working table, left and
right extension tables, then put the flat washers 6 [29], spring washers 6 [30] and
loosely tighten on the hex nuts M6 [31] as shown in the Fig. 4b.
> Reinstall the table insert [17].
Before you start
MSTS1500-A by MacAllister
Getting started...
25
EN
NOTE: The riving kinfe must be aligned with saw blade after
finished and the distance between the outside edge of the saw
blade and the riving knife must be three to eight millimetres. If
not, please contact with your dealer, because riving knife of this
table saw not need be adjusted.
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mac Allister MSTS1500-A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mac Allister MSTS1500-A in the language / languages: English as an attachment in your email.

The manual is 4.82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info