522609

M-System PRNF-965 Manual

111
Zoom out
Zoom in
Previous page
1/112
Next page
111
230 V
PEN
L
1
(L2)
Fig. 9.2
Fig. 9.1
D
B
PE
A
N
L
CONNECTING THE FEEDER CABLE
To connect the feeder cable to the cook-
er it is necessary to:
- Remove the screws securing the
cover “A” on the rear of the cooker
(fig. 9.1).
- Feed the supply cable through the
cable clamp “D”. The supply cable
must be of a suitable size for the
current requirements of the appliance;
see the section “Feeder cable
section”.
- Connect the wires to the terminal
block “B” as shown in the diagram in
figure 9.2; or connect the phase wires
to the terminal block “B” and the earth
wire to the terminal PE as shown in
figure 9.1.
– Pull the feeder cable and block it with
the cable clamp D.
– Re-mount shield A.
N.B. The earth conductor must be left
about 3 cm longer than the others.
FEEDER CABLE SECTION
Type “HO5RR-F”
230 V 3 x 1,5 mm
2
… 111


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for M-System PRNF-965 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of M-System PRNF-965 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info