743786
5
Zoom out
Zoom in
Previous page
1/7
Next page
II_Pulse_09_eng
Page 5 di 8
Mounting Instructions
BOLTWORK REQUIREMENTS AND MOUNTING INSTRUCTION
The bolt force applied must not exceed 1kN (contact the manufacturer if a force greater than that shown
is applied).
Use only the screws provided, screwing it in order to firmly fixed the lock to the mounting surface.
In the LOCKED position, there should be approximately 1 mm clearance between the
lock bolt and the cavity in the blocking bar of the boltwork. The lock bolt must move
freely into the cavity.
In OPEN position, there should be minimum
3mm and maximum 5 mm clearance between
the lock bolt and the bloching bar of the
boltwork.
Any component that is fixed to the bolt, must be approved before use.
Mount the keyboard by following the installation instructions.
The opening movement of the shaft must be inserted for a minimum of 10 mm and a maximum of 15
mm inside the lock.
ATTENTION: to prevent damage to the cable, do NOT insert the shaft
until the lock lid, but leave some margin to allow the movement of the cable.
Make sure the cable is fully inserted and locked into the groove on the shaft of the movement.
Remove any residue derived from shaft cutting, which could damage the cable.
Plug the cable connector into the square hole in the base of the lock and it comes out the other side.
Secure the cable in the proper groove on the lock cover
(not stretch)
and fix the same, using the
appropriate mounting screws.
Insert the connector of the entry unit in the outer position “ENT”.
Check that the connector
is completely seated (To remove the connector, lift it up and carefully pull it out).
Insert ALKALINE 9V battery in the keyboard or in the battery holder. A series of beeps during opening
indicates that the battery is low and needs to be replaced.
MOTORLOCK – DIMENSIONS
:
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for M-Locks Pulse Pro at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of M-Locks Pulse Pro in the language / languages: English as an attachment in your email.

The manual is 1,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of M-Locks Pulse Pro

M-Locks Pulse Pro User Manual - Dutch - 25 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info