586999
16
Zoom out
Zoom in
Previous page
1/68
Next page
Page 12
10. When complete, you will be prompted to restart the computer
After restart the driver will be installed and ready for use.
2.6 Using Multiple Hilos and/or Auroras
Up to six Lynx Aurora/TB and/or Hilo/TB interfaces can be daisy chained to a single Thunderbolt port. Each unit will
be addressable independently, and the combined I/O can be used by a DAW application.
Connecting multiple units requires consideration of the following:
2.6.1 Connect the cables
With the computer OFF, the first step is to connect the Thunderbolt and wordclock cables.
You will need one Thunderbolt patch cable for each Lynx LT-TB Interface in the system.
One cable should be connected from the computer’s Thunderbolt port to either port on the first unit. Then daisy chain
one at a time, from the open Thunderbolt port on unit 1, to either port on unit 2, out from unit 2 to unit 3, etc. It doesn’t
matter which port “receives” and which port “sends”.
Next we connect wordclock cables to each unit. If Hilo #1 is going to be the clock master, connect a wordclock cable
from unit #1 Wordclock Out, to unit #2 Wordclock In, then unit #2 Wordclock Out to unit #3 Wordclock In. etc.
If clock distribution is utilized, a single wordclock cable will go from each Hilo’s or Aurora’s “Wordclock In” port to
an output on the clock distributor. The Hilo and Aurora are self terminating, so there is no need for hardware
termination.
Make sure that the wordclock cables are 75, and as close to the desired length as possible to avoid clock signal phase
issues.
2.6.2 Setting Device Order
When mixing Hilo/TB and Aurora/TB interfaces, it is possible to establish the device order for the Aurora units.
Information is available about this process from the Aurora/TB manual in section 8.1.2.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lynx Hilo TB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lynx Hilo TB in the language / languages: English as an attachment in your email.

The manual is 3,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info