587002
19
Zoom out
Zoom in
Previous page
1/55
Next page
19
The channel mode can be changed within the Lynx Mixer. Click Settings > Advanced >
Adapter Settings, selecting the appropriate Aurora (if multiple are present) and then setting
the desired mode from the “Channels” Selection. Click “Save”. Turn the Aurora OFF then
ON again for the new channel mode to become active.
With multiple Auroras, each can be set to different channel modes if so desired. For instance
if there are three Auroras, but only 16 channels of AES Digital I/O is required, you could set
two Auroras to 16-channel mode, and one to 32-channel mode.
5.6 Device Order
In a multiple Aurora configuration, some of the newer operating systems have a tendency to
cause the order of devices to switch. For instance, on one boot cycle Aurora A will be device
1 and Aurora B will be device 2 within the OS. After a different boot cycle, this may change
so that Aurora B is device 1 and Aurora A is device 2.
The Lynx Mixer has a solution to this dilemma. Please see 8.1.1: Setting Device Order, for
details.
5.7 Verifying Successful Installation
To verify that the driver was successfully installed and is operational, launch the Lynx Mixer
application. In Windows this can be found at Start > All Programs > Lynx Studio
Technology > Lynx Mixer. In OS X the Lynx Mixer can be found in Applications.
With the Lynx Mixer open, verify that the SYNC SOURCE is on “Internal” Then change the
sample rate from the “Rate Select” combo box in the toolbar from 44.1 kHz to 96 kHz. Make
sure that the SAMPLE RATE on the Aurora front panel responds accordingly.
If the Lynx Mixer will not open, or it opens but you cannot change the sample rate, see
Section 9: Troubleshooting.
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lynx Aurora LT-TB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lynx Aurora LT-TB in the language / languages: English as an attachment in your email.

The manual is 0,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info