587002
9
Zoom out
Zoom in
Previous page
1/55
Next page
9
5 Installation Procedures
Please insure that the Aurora has firmware 28 or above before proceeding. See Section
2.2.3: Insuring compatible firmware
1. Remove the AC power cord and take the top cover off of the Aurora. There are seven
large screws plus one small alignment screw near the center-front of the top lid that holds
it on.
2. Before installing the LT-TB card, you must change a dipswitch setting on the Aurora that
corrects the current draw for an Aurora with an LT-TB. Please note: if you are replacing
a different LSLOT card with the LT-TB, it’s likely that the dipswitch setting is already in
the correct position.
Slide switch 4 (labeled W4 on PCB) of SW1 to the OFF position (towards back panel).
If you are updating an older Aurora that has jumper pins at JP6, instead of the W4
switches, please call Lynx Technical Support for instructions.
3. Remove the LSLOT Expansion Port cover above the AES I/O Ports by removing the two
mounting screws. Set these two screws aside, as they will be used to secure the LT-TB
after installation.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lynx Aurora LT-TB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lynx Aurora LT-TB in the language / languages: English as an attachment in your email.

The manual is 0,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info