541008
100
Zoom out
Zoom in
Previous page
1/118
Next page
To change the mode of operation, press the MODE button for approximately 2
seconds. If the radial LEDs run from top to bottom this means change over to
nearest mode and vice versa. After any power off followed by power on the
mode active before switching off will remain.
10.1.1.1 Obstacles
Flarm unit is capable of storing co-ordinates of obstacles which could cause a collision during
flight. This data is available on www.flarm.com (see Chapter 10.1.4). The unit is factory
pre-loaded with current obstacle database. An obstacle warning will be activated if an
obstacle is found in front of the glider and a collision risk is predicted. After a low level
warning has been activated two upper LEDs will be active (such a situation will never appear
with glider v glider collision risk). Medium and high risk will be indicated with more LEDs
active and higher frequency audio signal.
To change the audio warning volume, briefly press the mode selector; each press will
increase the audio volume (three levels and mute available).
To change the mode of operation, press the MODE button for approximately 2
seconds. If the radial LEDs run from top to bottom this means a change over to
nearest mode and vice versa. After each new power on the unit will start in
Nearest mode.
10.1.1.2 Settings for the LX Flarm LED Display
Using the MODE key it is possible to adjust some parameters of the external display.
Disconnect the unit, press the MODE selector and hold. Power on and hold the MODE
selector for about 4 seconds. The display parameters can be defined by pressing the MODE
selector for approximately 2 seconds and observing green LEDs. To move between
parameters briefly press MODE and observe the red LEDs.
Parameter
LED
Red LED
018˚
Red LED
054˚
Red LED
090˚
Red
LED126˚
Red
LED162
˚
Red LED
198˚
Twin cfg.
Tx
PIC
PAX
Baud rate
Tx+Rx
4800 bps
9600 bps
19200 bps
-------
38400
bps
57600
bps
In conjunction with the LX 8000 use exclusively 19200 bps.
If two units work in parallel (two-seat aircraft) one unit must be designated PIC and the
other PAX.
100


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for LX NAV LX 8000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of LX NAV LX 8000 in the language / languages: English as an attachment in your email.

The manual is 8,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of LX NAV LX 8000

LX NAV LX 8000 User Manual - German - 158 pages

LX NAV LX 8000 Quick start guide - Dutch - 15 pages

LX NAV LX 8000 User Manual - Dutch - 81 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info