541008
62
Zoom out
Zoom in
Previous page
1/118
Next page
even if the item is checked.
It is possible to store map settings for future use. There are two memory locations MEM 1
and MEM 2 for two different memory settings.
Press button MEM 1 for a long time. A message
“Options stored to memory (1)”
will be
displayed and the settings are stored. Change the settings a little bit. Press button MEM 2
for long time. A message
“Options stored to memory (2)”
will be displayed and the settings
are stored to memory location 2. Now short pressing of MEM 1 will invoke the saved
settings from memory 1.
5.5.5.4 Wind
The LX8000 constantly calculates winds using four different methods. Speed difference
method is used during circling and is taking into account ground speed difference in a single
circle. Position drift is calculating wind based on position drift during circling. A minimum
of three circles must be completed to obtain the first wind measurements. The third method
is combination, which takes into account also airspeed received from the vario unit.
If the compass module is available wind is also estimated using the wind triangle. Calculated
wind is stored in layers. Layer height is 300 m or 1000 ft and cannot be modified by the
user.
The wind profile is shown on the left side of the dialogue. Yellow coloured altitude indicates
our current MSL altitude. Using the lower-left knob you can scroll up and down through the
wind layers.
Use the EDIT button to manually enter wind data. If a new wind direction is entered all
wind directions in range from start altitude to end altitude will be modified. The same
procedure is used for wind speed.
The user can also disable or enable a particular wind method. It is recommended to have all
methods enabled.
Once the wind is modified to suit your needs press the OK button to accept the wind values.
The dialogue will exit automatically.
If the CANCEL button is pressed the wind dialogue will be closed without applying the
changed values.
62


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for LX NAV LX 8000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of LX NAV LX 8000 in the language / languages: English as an attachment in your email.

The manual is 8,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of LX NAV LX 8000

LX NAV LX 8000 User Manual - German - 158 pages

LX NAV LX 8000 Quick start guide - Dutch - 15 pages

LX NAV LX 8000 User Manual - Dutch - 81 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info