775741
2
Zoom out
Zoom in
Previous page
1/12
Next page
ENGLISH - USER MANUAL
AngelSounds - fetal doppler
1. On/O/volume slider
2. Power indicator light
3. Headphone socket(two)
4. Sensor
5. Battery compartment cover
Accessories
Introduction
The AngelSounds fetal doppler is a single-hand device
for detection of the fetal heart. The fetal heart may be
detected from early pregnancy, and more easily from
pregnancies greater than 12 weeks. Every AngelSounds
is supplied with a dry-cell battery. A dry-cell battery must
NOT be placed in a recharging device and must NOT be
disposed of by burning. The AngelSounds fetal doppler
operates at a nominal frequency of 3.3MHz, using Dop-
pler ultrasound. There is an on/o/volume key(1)’, it’s easy
to operate. The LED working indicator light (2) shows
working condition. A headset and an audio line are avail-
able. The AngelSounds fetal doppler is lightweight and
designed to t comfortably in your hand.
Operation instruction
Insert the headset jack securely into the socket(3). Apply
a small amount of acoustic coupling gel to the examina-
tion site. Or put some gel on the top of the sensor (4).
Switching on On/O/volume key (1)
This key is used to select either high or low volume level,
too. Hold the AngelSounds Fetal doppler. Plug in the
earphones.
The AngelSounds fetal doppler is now ready for use.
Operation
Place the transducer on the examination site and move
it around slowly until a good signal is obtained. This will
sound like galloping horses’. It may be necessary to angle
the transducer slightly to obtain the optimum signal.
Use of audio line
Insert one jack of the audio line into the main unit’s
headset socket (any of the two), put another plug into the
recorder, then the fetal heart beat can be recorded by the
recorder. Move the transducer to the pregnant womans
left chest to record her heart beat and play the mother’s
heart beat to the baby. After the baby is born, this can
calm the baby down. To switch o, just turn the ‘On/O/
Volume Slider’.
Battery tting or replacement
How to t or replace the battery on the AngelSounds
fetal doppler:
Remove the rear battery compartment cover (5) carefully.
Remove the old battery. Fit the new battery (IEC6F22 9V
alkaline). Then close the battery cover.
• Use only the specied battery type and insert the
battery according to polarity instruction (check the
+ and – poles).
• Always dispose of empty batteries in accordance
with regulations. Do not dispose together with
household garbage.
New alkaline battery will give more than 500 one minute
examinations. Battery should be removed if the unit is
not in regular use. After use, the AngelSounds fetal dop-
pler should be dried thoroughly with a soft cloth.
2
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Luvion AngelSounds at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Luvion AngelSounds in the language / languages: Dutch, French as an attachment in your email.

The manual is 1.3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info