708359
21
Zoom out
Zoom in
Previous page
1/24
Next page
Part VI: Troubleshooting and Parts List
13
Rack catching on tail
tube (at end of stroke).
Rack returning very slow
or not going all the way
back.
Adjust carriage hold downs (slide guides).
Check for wood chips or debris between ram bushing plate and
beam.
Check rack lift bearing for alignment or damage.
Return spring is unhooked or damaged. Reconnect or replace as
needed.
Machine wedge end too low. Must be almost level or wedge end
slightly higher.
Operator Lever
Snapping out of gear or
not staying in gear.
Lever not all the way forward when rack comes under full load.
Push lever quicker and more forcefully into the full forward
position.
Ram has been overloaded at lower part of face. Check rack gear
for straightness.
Rack slamming back too
fast.
Wedge end of machine too high. Must be almost level with ram
end or just slightly higher.
Springs not operating properly. Fix or replace as needed.
Machine does not seem
to have full splitting
power.
The belts may be too loose and slipping. Adjust or replace belts as
needed.
Operator Lever not
engaging rack with
pinion gear.
Clean wood chips or other debris from under rack.
Clean accumulated dirt from frame where carriage assembly rests
against rubber bumpers.
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lumag HC15 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lumag HC15 in the language / languages: English as an attachment in your email.

The manual is 1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Lumag HC15

Lumag HC15 User Manual - German - 32 pages

Lumag HC15 User Manual - Dutch - 52 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info