Manual Lowrance X52 (page 75 of 84) (English)

28399

Zoom out

Zoom in

1/84

Troubleshooting

If your unit is not working, or if you need technical help, please use the

following troubleshooting section before contacting the factory customer

service department. It may save you the trouble of returning your unit

for repair. For contact information, refer to the last page, just inside the

back cover of this manual.

Unit won't turn on:

1. Check the power cable's connection at the unit. Also check the

wiring.

2. Make sure the power cable is wired properly. The red wire connects

to the positive battery terminal, black to negative or ground.

3. Check the fuse.

4. Measure the battery voltage at the unit's power connector. It should

be at least 11 volts. If it isn't, the wiring to the unit is defective, the

battery terminals or wiring on the terminals are corroded, or the

battery needs charging.

Unit operates only in demo mode:

1. The transducer has not yet been connected or has been disconnected.

To leave demo mode, make sure the transducer is securely connected

before turning the unit on.

Unit freezes, locks up, or operates erratically:

1. Electrical noise from the boat's motor, trolling motor, or an accessory

may be interfering with the sonar unit. Rerouting the power and

transducer cables away from other electrical wiring on the boat may

help. Route the sonar unit's power cable directly to the battery instead

of through a fuse block or ignition switch

2. Inspect the transducer cable for breaks, cuts, or pinched wires.

3. Check both the transducer and power connectors. Make sure both are

securely plugged in to the unit.

Weak bottom echo, digital readings erratic, or no fish signals:

1. Make sure the transducer is pointing straight down. Clean the face of

the transducer. Oil, dirt and fuel can cause a film to form on the

transducer, reducing its effectiveness. If the transducer is mounted

inside the hull, be sure it is shooting through only one layer of

fiberglass and that it is securely bonded to the hull. When attaching a

transducer to the inside of a hull, ONLY use the epoxy available from

LEI (order information is inside the back cover). Do NOT use RTV

silicone rubber adhesive or any other type of epoxy. The LEI epoxy is

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Lowrance X52 in the language / languages: English as an attachment in your email.

The manual is 2,14 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Lowrance X52 Manual

Product: