599367
20
Zoom out
Zoom in
Previous page
1/51
Next page
3. Don’t mount the transducer directly behind strakes or ribs on the
bottom of the hull. Typically, a good location on aluminum boats is
between the ribs closest to the engine.
4. Once you determine the best location for the transducer, hold the
bracket against the transom. The transducer should be roughly paral-
lel to the ground. The bottom of the hull should be about halfway
between the centerline of the transducer and its bottom. (See the
illustration below.)
GOOD LOCATION
POOR LOCATION
POOR ANGLE
GOOD LOCATION
Mark the transom in the center of each slot in the transducer bracket.
Now drill one hole in the center of each slot. Use #12 stainless steel
screws (not included) to loosely attach the brackets to the transom.
5. Adjust the transducer and bracket so that the front of the transducer is
slightly lower than the back. See the section on fish arches in this
manual for proper transducer angles. Tighten all screws. Clamp the
transducer cable to the transom close to the transducer. This will
prevent the transducer from entering the boat should it be knocked
off at high speed.
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lowrance X-85 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lowrance X-85 in the language / languages: English as an attachment in your email.

The manual is 0,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info