599366
21
Zoom out
Zoom in
Previous page
1/51
Next page
FLAT-BOTTOM HULL
DEEP-"VEE" HULL
6. Route the transducer cable to the sonar unit. Keep the transducer
cable away from other wiring on the boat, if possible. Electrical noise
from engine wiring or bilge pumps can be picked up on the trans-
ducer cable. This can show up as unwanted interference on the
sonar display.
NOTE: Some aluminum boats with strakes or ribs on the outside of the
hull create large amounts of turbulence at high speed. These boats
typically have large outboard motors capable of propelling the boat at
speeds over 35 mph. The transducer should be mounted as far below
the hull as possible on these boats. This will place the face of the
transducer below the turbulent water, allowing the sonar unit to work at
high speeds.
7. Make a test run to determine the results. If there is interference on the
display when running the boat at high speed, try lowering or changing
the angle of the transducer.
Periodically wash the transducer's face with soap and water to
remove any oil film. Oil and dirt on the face will reduce the
sensitivity or may even prevent operation.
NOTE
CAUTION!
MAKE CERTAIN TO CLAMP THE TRANSDUCER CABLE TO
THE TRANSOM NEAR THE TRANSDUCER. THIS WILL HELP
PREVENT THE TRANSDUCER FROM ENTERING THE BOAT IF
IT IS KNOCKED OFF AT HIGH SPEED.
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lowrance X-75 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lowrance X-75 in the language / languages: English as an attachment in your email.

The manual is 0,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info