599440
15
Zoom out
Zoom in
Previous page
1/28
Next page
11
4. Route the radar cable to the RIM 100 location. Connect the RIM 100
radar data cable to the radar antenna power/data output cable using
heat-shrink butt connectors. Follow instructions on the wiring diagram
that corresponds to your radar antenna — Detail Drawing A for radome
models or Detail Drawing C for open array models. Diagrams are
shown on pages 11 through 14.
5. Connect the RIM 100 RS-232 data cable to the display unit RS-232
cable using heat-shrink butt connectors. Follow the instructions on the
wiring diagram that corresponds to your radar antenna — Detail
Drawing B for radome models or Detail Drawing D for open array mod-
els.
RIM 100 RS-232 Power/Data Cable
6. The RIM 100's serial device data cable is unused at this time. To pro-
tect the wire ends for future use — and prevent accidental shorts — un-
used wires should be wrapped in electrical tape or capped with wire nuts.
7. Connect the RIM 100 power cable to the same 12-volt power source
as the radar's display unit. The red wire is + and the black wire is –.
8. After wires have been connected and unused wires insulated, insert
the module's power/data cable plug in the receptacle on the RIM 100.
RIM Data
RIM Pw
r
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lowrance Radar and RIM 100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lowrance Radar and RIM 100 in the language / languages: English as an attachment in your email.

The manual is 0,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info