599173
42
Zoom out
Zoom in
Previous page
1/66
Next page
40 |
Software setup | HDS Gen3 Installation Manual
‘Uncon gure is for defaulting the device clearing all user settings,
and ‘Reset Fuel Flow will restore only the ‘Fuel K-Value setting, if set
in ‘Calibrate. Only Navico devices can be reset.
Calibrate
While default calibration is usually accurate enough, it is possible
to apply further calibration to accurately match measured  ow
with actual fuel  ow. Access calibration from the ‘Refuel’ dialog.
Calibration is only possible on Navicos Fuel Flow sensor.
1. Start with a full tank and run the engine as it would normally be
operated.
2. After at least several litres (a few gallons) have been used, the tank
should be fully re lled, and the ‘Set to full’ option selected.
3. Select the ‘Calibrate’ option.
4. Set the ‘actual amount used’ based on amount of fuel added to
tank.
5. Select OK to save settings. The ‘Fuel K-Value’ should now show a
new value.
Note: Not correctly following the calibration procedure could result
in erroneous fuel data.
Note: To calibrate multiple engines repeat the steps above, one
engine at a time. Alternatively, run all engines simultaneously, and
divide the ‘Actual amount used’ by the number of engines. This
assumes reasonably even fuel consumption on all engines.
Note: Calibrate option is only available when ‘Set to full’ is selected,
and a Fuel Flow sensor is connected and set up as a source.
Note: A maximum of 8 engines are supported using Fuel Flow
sensors.
42


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lowrance HDS Gen3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lowrance HDS Gen3 in the language / languages: English as an attachment in your email.

The manual is 7,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Lowrance HDS Gen3

Lowrance HDS Gen3 User Manual - English - 184 pages

Lowrance HDS Gen3 Quick start guide - German - 8 pages

Lowrance HDS Gen3 User Manual - German - 176 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info