623838
20
Zoom out
Zoom in
Previous page
1/40
Next page
18 |
Wiring | HDS Gen2 Touch Installation Manual
Power connection
HDS Gen2 Touch displays are designed to be powered by a 12 V DC
system. They are protected against reverse polarity, under voltage
and over voltage.
The plug of the supplied power cable has two discrete cables exiting
from it. The thickest cable provides the following:
• power into the system (Red and Black wires)
• remote turn-on for certain Navico expansion modules (Yellow wire)
+
_
2
3
4
6
5
1
1 HDS display rear (9 & 12 connector arrangement shown)
2 Power cable
3 12 V negative wire (black)
4 12 V positive wire (red) shown with fuse holder tted
5 Accessory Wake Up wire (yellow)
6 Vessel’s 12 V DC supply
Connect red to (+) DC using a 5 A fuse. Connect Black to (-) DC.
Accessory wake up
The yellow colored accessory wake up line may be used to
control the power state of Navico modules such as SonicHub,
StructureScan, and Broadband radar. This means that the modules
are turned on the moment the display is powered up.
¼ Note: Broadband radar will be put in standby, when triggered by the
accessory wake up line.
For connection, simply combine all yellow wires on a common bus
or to a single termination point.
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lowrance HDS-9 Gen2 Touch at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lowrance HDS-9 Gen2 Touch in the language / languages: English as an attachment in your email.

The manual is 8,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Lowrance HDS-9 Gen2 Touch

Lowrance HDS-9 Gen2 Touch User Manual - English - 137 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info