599177
17
Zoom out
Zoom in
Previous page
1/52
Next page
16
Aligning Ratchets on Transducer bracket
Aligning ratchets on one-piece bracket:
The one-piece bracket assembly includes two black plastic ratchets. The ratchets are used to
align the transducer with the boat hull. Each ratchet has the letters A-E molded into it.
3: Hold the transducer assembly against the
transom. Look at the transducer from the
side.Try to adjust the transducer so its face
is parallel to the ground. If it does, then the
"A" position is correct.
Transom
2: Slide the transducer in the
bracket and temporarily
slide the bolt through the
transducer bracket, as
shown in the image at
right.
1: Insert the ratchets in the bracket with the
letter "A" aligned with the dot stamped on the
outside of the transducer bracket, as shown in
the following series of diagrams.
Ratchet
Bracket
Align dot and
letter "A".
If the transducer will not adjust with its face parallel to the ground, remove the transducer and
ratchets from the bracket. Reinsert the ratchets into the bracket, this time with the letter “B”
aligned with the dot stamped in the bracket.
Reassemble the transducer and bracket and place it against the transom. Again, check to see if
the transducer will adjust so its face is parallel with the ground. Repeat this process until the
transducers face will adjust so that it is parallel with the ground.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lowrance HDS-8 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lowrance HDS-8 in the language / languages: English as an attachment in your email.

The manual is 9,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Lowrance HDS-8

Lowrance HDS-8 Quick start guide - English - 6 pages

Lowrance HDS-8 User Manual - English - 134 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info