599177
126
Zoom out
Zoom in
Previous page
1/134
Next page
124
Troubleshooting
Highlight FORCE STATUS UPDATE and press ENT.
Pay attention to the RX/TX buttons.
c. If the TX is not lighting up then either you do not have
the com port set to RADAR or the GPS unit is defective.
Verify that the Com Port is set properly, if it is then the
Lowrance unit will need to be sent in for repair.
d. If the TX is blinking but the RX is not then you are not
getting any information from the RIM, the processor or
the Radar. There is a fuse inside the processor that
has more than likely blown. Remove the front left black
screw, then remove the grounding post on the right side
of the front of the unit. Gently slide the front cover off,
the fuse is located on the left side of the board. This
fuse is very tight and difcult to remove, you may need
to use a pair of pliers to get a good grip on it and gently
try to pull it out. Replace the fuse, the faceplate, and
the screws, making sure that the front face is securely
seated so not to lessen the water seal.
4. If the communication is hooked up properly and all informa-
tion elds are properly displayed on the “radar information”
page, but the unit starts to warm up but you never see a
count down to standby on the screen and then radar com-
munication is lost after one minute. The voltage supply to
the Radar Antenna or the gauge wire supplying the voltage
may be to small.
126


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lowrance HDS-8 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lowrance HDS-8 in the language / languages: English as an attachment in your email.

The manual is 4,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Lowrance HDS-8

Lowrance HDS-8 Quick start guide - English - 6 pages

Lowrance HDS-8 Installation Guide - English - 52 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info