599176
21
Zoom out
Zoom in
Previous page
1/52
Next page
20
1: Hold the transducer and bracket
assembly against the transom.
When the transducer and bracket
are properly aligned mark its
position on the hull.
2: Drill the mounting holes for the
transducer bracket. For the one-
piece bracket use a #29 bit (for
the #10 screws). For the two-piece
bracket use a #20 bit (for the #12
screws).
Clamp the transducer cable to the
transom near the transducer. This
will help keep the cable secure.
If you drill a hole in the transom for
the transducer cable, make sure it
is located above the waterline. Seal
the hole with an above- or below-
waterline marine grade sealant.
Water line
When mounting a Skimmer
transducer to a boat with a veehull,
make sure the transducer center
line is aligned to the bottom of the
boat hull, as shown here.
Be sure to use a below-waterline
marine grade sealant on all of the
transducer bracket screw holes.
Note: Use the provided screws to secure the transducer assembly to the transom.
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lowrance HDS-7m at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lowrance HDS-7m in the language / languages: English as an attachment in your email.

The manual is 9,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Lowrance HDS-7m

Lowrance HDS-7m Quick start guide - English - 6 pages

Lowrance HDS-7m User Manual - English - 132 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info