599174
119
Zoom out
Zoom in
Previous page
1/132
Next page
117
Troubleshooting
transducer cables away from other electrical wiring on the
boat.
3. When trolling over weed beds in 20ft of water or less, you
may experience vertical bars, loss of the chart picture, or
the digital depth. First, do a soft reset of the unit. Then go
to the Full Sonar Chart screen. Press Menu and select So-
nar Features. Now turn the Chart Manual Mode to On. This
will leave everything in Automatic Mode except depth. Now
go back to the main menu and set the depth range for the
depth you are in such as 0-20 feet.
4. It can sometimes be difcult for a high-powered unit to cap-
ture the lightning-fast return in shallow water. Turn off the
automatic sensitivity setting and manually reduce the sensi-
tivity until the unit locks onto the bottom.
5. If two or more sonar units using the same frequency are op-
erating at the same time, one or more of them may lose the
depth reading due to the interference. It is like two radio sta-
tions trying to both broadcast on 97.3FM. In shallow water,
if the transducers are far enough apart, you may be able to
operate them together. However, the deeper the water, the
wider the beams spread out. When they cross each other,
the interference occurs.
1. If you are using a transom-mounted transducer, the angle
of the transducer may prevent a sh arch from displaying
properly. If the arch slopes up but not down, then the front of
the transducer is too high and needs to be lowered. If only
the back half of the arch is shown, the nose of the trans-
ducer is angled too low and needs to be raised. This is the
most common problem if a partial arch is displayed.
2. The sensitivity may not be high enough. For the unit to dis-
play a sh arch, it has to be able to receive the sh’s echo
from the time it enters the cone until it leaves. If the sensitiv-
ity is not high enough, the unit shows the sh only when it is
in the center of the cone.
3. Use the Zoom feature. It is much easier to display sh arch-
es when zoomed in on a small range of water than a large
one. If your boat is in water deeper than 20ft, try setting the
upper and lower limits to a 20ft depth section, such as 40ft
No sh arches when Fish I.D. is turned off
119


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lowrance HDS-7 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lowrance HDS-7 in the language / languages: English as an attachment in your email.

The manual is 4,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Lowrance HDS-7

Lowrance HDS-7 Quick start guide - English - 6 pages

Lowrance HDS-7 Installation Guide - English - 52 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info