470141
4
Zoom out
Zoom in
Previous page
1/28
Next page
4
Aligning ratchets on two-piece bracket:
The two-piece bracket includes four black plastic ratchets. The ratch-
ets are used to align the transducer with the boat hull. Each ratchet has
the letters A-F molded into it.
If the transducer will not adjust with its
face parallel to the ground, remove the
transducer and ratchets from the brack-
et. Reinsert the ratchets into the bracket,
this time with the letter "B" aligned with
the dot stamped in the bracket. Reassemble the transducer and bracket and place it
against the transom. Again, check to see if the transducer will adjust so its face is
parallel with the ground. Repeat this process until the transducers face will adjust so
that it is parallel with the ground.
1. Place two of the ratchets in each side of the bracket
with the letter "A" aligned with the alignment mark molded
into each bracket.
2. Now place the other two ratchets on
the transducer with the letter "A" aligned
in the 12 o'clock position on the trans-
ducer stem.
Ratchet
Bracket
Alignment
mark
4. Hold the transducer assembly
against the transom. Look at the
transducer from the side. Try to
adjust the transducer so its face
is parallel to the ground. If it does,
then the "A" position is correct.
3. Slide the transducer in the bracket
and temporarily slide the bolt through
the transducer bracket.
Transom
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lowrance HDS-5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lowrance HDS-5 in the language / languages: English as an attachment in your email.

The manual is 5,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Lowrance HDS-5

Lowrance HDS-5 Quick start guide - English - 6 pages

Lowrance HDS-5 User Manual - English - 129 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info