599178
22
Zoom out
Zoom in
Previous page
1/52
Next page
21
If you drill a hole in the transom for the transducer cable, make sure it is located above
the waterline. Seal the hole with an above or below waterline marine grade sealant. Route
the transducer cable to the sonar unit. Make sure to leave some slack in the cable near the
transducer.
Use caution when routing the transducer cable near other wiring and cables. If you need to
drill a hole in the transom to pass the connector through, the hole size will depend on the
connector on the end of the transducers cable.
Make a test run to determine the results
At times you may need to adjust the transducer higher or lower. The slots in the mounting
brackets allow you to loosen the screws and slide the transducer up or down.
If the sonar screen is displaying partial sh arches, as shown in the previous top two images,
the transducer could be at an improper angle. Check the transducer and make sure its face is
parallel with the bottom, as shown in the bottom example. If you frequently lose bottom signal
lock the transducer may be coming out of the water as the boat crosses waves or wakes.
Move the transducer a little lower in the water to see if that improves sonar performance.
When shing around underwater structure the transducer may be kicked up from object
strikes. If the transducer is being kicked up too often, try moving it a little higher for more
protection.
Partial sonar
sh arches
Improper transducer
angles
Full sonar sh arch
Transducer face parallel
with the bottom.
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lowrance HDS-10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lowrance HDS-10 in the language / languages: English as an attachment in your email.

The manual is 9,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Lowrance HDS-10

Lowrance HDS-10 Quick start guide - English - 6 pages

Lowrance HDS-10 User Manual - English - 134 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info