599178
119
Zoom out
Zoom in
Previous page
1/134
Next page
117
Troubleshooting
If your unit is not working, or if you need technical help, use the following
troubleshooting section before contacting the customer service department.
1. Check the power cable’s connection at the unit.
2. Make sure the power cable is wired properly. The red wire
connects to the positive battery terminal, black to negative
or ground.
3. Check the fuse.
4. Measure the battery voltage at the unit’s power connector.
You will measure the two biggest pins. It should be at least
10 volts. If it isn’t, the wiring to the unit is defective, the bat-
tery terminals or wiring on the terminals are corroded, or the
battery needs charging.
1. Electrical noise from the boat’s motor, trolling motor, or an
accessory may be interfering with the sonar unit. Rerouting
the power and transducer cables away from other electrical
wiring on the boat may help. Route the sonar unit’s power
cable directly to the battery instead of through a fuse block
or ignition switch.
2. Inspect the transducer cable for breaks, cuts, or pinched
wires.
3. Check the transducer and power connector. Make sure it’s
securely plugged into the unit.
1. Make sure face of the transducer is parallel to the ground.
(Refer to the installation manual for more information.)
2. If the transducer is mounted inside the hull, be sure it is
shooting through only one layer of berglass, that it is
securely bonded to the hull and DOES NOT have air
Troubleshooting
Unit won’t turn on
Unit freezes, locks up, or operates erratically
Weak bottom echo, erratic readings or no sh returns
119


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lowrance HDS-10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lowrance HDS-10 in the language / languages: English as an attachment in your email.

The manual is 4,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Lowrance HDS-10

Lowrance HDS-10 Quick start guide - English - 6 pages

Lowrance HDS-10 Installation Guide - English - 52 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info