599375

Lowrance GlobalMap 2000 Manual

5
Zoom out
Zoom in
Previous page
1/92
Next page
3
The smallest hole that will pass the power plug is one inch. After the hole
is drilled, pass the other cables up through the hole first, then pass the
power cable down through it.
After the cables have been routed, fill the hole with a good marine sealing
compound. Offset the bracket to cover the hole. Route the cables through
the slot in the back of the bracket. There are two “knockout” plugs in the
rear of the bracket that can be removed to route cables, if necessary.
MOUNTING - In-Dash Mount
The mapping unit can be installed in the dash with the supplied hardware
if the dash is 1/2" thick or less. Measure the dash thickness in the area you
need to mount the unit, since dash thickness can vary. If it’s thicker than
1/2", you’ll need the FM-2 in-dash mounting bracket accessory. Make
certain there is clearance behind the dash for the unit and there is enough
room to tighten the bolts on both sides.
Once you’ve determined the location for the unit, cut the hole according to
the drawing shown above. Measure carefully before cutting! After cutting
the dash, slide the supplied gasket around the unit and place the unit in the
hole.
Supplied with this unit are rubber pads, bolts, washers, and cam clamps
to attach it to the dash. Peel the adhesive backing off the rubber pads and
place one on each side of the unit in the location where the cam clamp will
touch the back side of the dash. Using the hardware supplied with the unit,
attach the unit to the dash. Looking at the back of the unit, make certain that
the cam clamp on the left side of the unit is pointing down and the cam
7.625"
5.375"
DASH CUTOUT
.400" radius
(4 places)
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lowrance GlobalMap 2000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lowrance GlobalMap 2000 in the language / languages: English as an attachment in your email.

The manual is 0,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info