Manual Lowrance GlobalMap 1600 (page 14 of 92) (English)

599374

Zoom out

Zoom in

1/92

Transducer Assembly and Mounting

The best way to install this transducer is to loosely assemble all of the

parts first, then place the transducer’s bracket against the transom and

see if you can move the transducer so that it’s parallel with the ground.

1. Press the two small plastic ratchets into the sides of the metal bracket

as shown below. Notice there are letters molded into each ratchet. Place

each ratchet into the bracket with the letter “A” aligned with the dot

stamped into the metal bracket. This position sets the transducer’s

coarse angle adjustment for a fourteen (14) degree transom. Most out-

board and stern-drive transoms have a fourteen degree angle.

DOT

2. Slide the transducer between the two ratchets. Temporally slide the bolt

though the transducer assembly and hold it against the transom. Look-

ing at the transducer from the side, check to see if it will adjust so that

its face is parallel to the ground. If it does, then the “A” position is cor-

rect for your hull. If the transducer’s face isn’t parallel with the ground,

remove the transducer and ratchets from the bracket. Place the ratch-

ets into the holes in the bracket with the letter “B” aligned with the dot

stamped in the bracket. Reassemble the transducer and bracket and

place them against the transom. Again, check to see if you can move

the transducer so it’s parallel with the ground. If it does, then go to step

3. If it doesn’t, repeat step 2, but use a different letter until you can

place the transducer on the transom correctly.

RATCHETS

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Lowrance GlobalMap 1600 in the language / languages: English as an attachment in your email.

The manual is 0,85 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Lowrance GlobalMap 1600 Manual

Product: