Manual Lorus Z017 (page 2 of 2) (English)

593915

Zoom out

Zoom in

1/2

The miniature battery SEIKO CR2016, Maxell CR2016

or SONY CR2016 which powers your watch should

last approximately 4 years. However, because it is

inserted at the factory, the actual life of the battery

once in your possession may be less than 4 years.

Be sure to replace the battery to prevent any

possible malfunction as soon as it runs down. To

replace the battery we recommend taking the

watch to a local watch repair shop.

Note: If the alarm is used for more than 20 seconds

a day and/or the illuminating light for more

than 8 seconds a day, the battery life may

be less than the specified period.

■

BATTERY CHANGE

■

HOW TO SET THE SECOND TIME ZONE

■

ILLUMINATING LIGHT

In any mode press

to illuminate the display for

about 3 seconds.

Note:

1. The backlight of the watch employs an electro-

luminescent (EL) light, which tends to lose

illuminating power after very long use.

2. The illumination provided by backlight may be

hard to see when viewed under direct sunlight.

■

CARE OF YOUR LORUS WATCH

This watch contains precise electronic components.

Never attempt to open the case or remove the

back cover.

• BATTERY

CAUTION

Do not expose the old battery to ﬁre or

recharge it. Keep it at a place beyond

the reach of chil dren. If a child swallows

it, consult a doctor immediately.

• WATERRESISTANT

Condition

of use

Accidental

contact

with water,

such as

splashes

and rain

Swimming

and taking

a shower

Skin

diving

Scuba

diving

Indication

on the dial/

case back

Indication

* If your watch is 200 M/20 BAR, 100 M/10 BAR

or 50 M/5 BAR water resistant, it is so indicated

on the dial/case back.

• Donotoperatethebuttonswhenthewatchis

wet.

• Ifthewatchisexposedtosaltwater,rinseitin

fresh water and then wipe it thoroughly dry.

• Shouldyoufindanywaterorcondensation

inside the watch, immediately have it checked.

Water can corrode electric parts inside the

case.

NO NO NO

YES YES NO NO

YES YES NO

YES

WATER

RESISTANT

WATER

RESISTANT

(50M/5BAR

)

WATER

RESISTANT

100M/10BAR

or above

(

Caution:

Leather straps are not water resistant except

so indicated, even if the watch head is water

resistant.

• ALLERGICREACTION

Because the case and band touch the skin

directly, it is important to clean them regularly. If

not, shirt sleeves may be stained and those with

delicate skin may develop a rash. Please wear

the watch with some play to avoid any possible

allergic reaction. If you develop a rash on your

wrist, stop wearing and consult a physician.

• MAGNETISM

Your watch will be adversely affected by strong

magnetism.Keep it away from close contact with

magnetic objects.

• SHOCKSANDVIBRATIONS

Your watch may be worn for normal sports

activities, but be careful not to drop it or hit it on

hard surfaces.

• TEMPERATURE

Your watch is preadjusted so that constant

accuracy may be insured at normal tem pera ture.

• CLEANING

Use only a soft cloth and clean water for cleaning

your watch. Never use chemicals, as the

waterproof gasket will corrode.

■

SERVICE

When your LORUS watch requires repair or

servicing, please see the enclosed WARRANTY/

GUARANTEE.

Printed in China

TIMER OPERATION

1. Press

in the TIMER mode to start the timer.

2. Press

to stop the timer.

3. To reset the timer to its starting value, press

4. Press

to return to the NORMAL TIME mode.

From 3 minutes before the time is up, the warning

beeps (BI-BI) will be generated each time the

second digits reach “00” and “30.” For the last 10

seconds before the time-up time, the alarm (BI)

will sound. When the time is up, the alarm (BI-BI-BI)

sounds for 10 seconds. Press

to stop it.

Start

Stop

Reset

(to its starting value)

YES

From the NORMAL TIME mode, press

four times

to go to the SECOND TIME ZONE mode. The SECOND

TIME ZONE mode indicator appears on the display.

1. Press

to change the display to the TIME ZONE

SETTING mode. The hour digits start flashing.

2. Press

to set the hour digits. One digit (flashing)

is increased with each press of

. To move the

digits quickly, keep

pressed.

3. Press

to confirm the hour setting and move

on to the minute setting. The minute digits start

flashing.

4. Press

to set the minute digits. The minute digits

are increased in 30-minute increments.

5. Press

to complete the second time zone

setting.

6. Press

to return to the NORMAL TIME mode.

■

HOW TO USE THE TIMER

From the NORMAL TIME mode, press

three times

to go to the TIMER mode. The TIMER mode indicator

“TR” appears on the display.

1. Press

to change the display to the TIMER

SETTING mode. The hour digits start flashing.

2. Press

to set the hour digits. One digit (flashing)

is increased with each pressing of

. To move

the digits quickly, keep

pressed.

3. Press

to confirm the hour setting and move

on to the minute setting. The minute digits start

flashing.

4. Press

to set the minute digits. One digit

(flashing) is increased with each pressing of

To move the digits quickly, keep

pressed.

5. Press

to confirm the minute setting and move

on to the second setting. The second digits start

flashing.

6. Press

to set the second digits. One digit

(flashing) is increased with each pressing of

To move the digits quickly, keep

pressed.

7. Press

to complete the timer setting.

TIMER mode indicator

SECOND TIME ZONE

mode indicator

NREZ017.indd 2 12/01/31 10:07

I am having difficulty changing the format to 24 hour clock on my new z017 r23 series watch I have read the manual, got it up onine and still cannot understand how to do this option - please help!! Submitted on 21-5-2017 at 19:36
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Lorus Z017 in the language / languages: English as an attachment in your email.

The manual is 1,12 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Lorus Z017

Lorus Z017 User Manual - German - 2 pages

Lorus Z017 User Manual - Dutch - 2 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Lorus Z017 Manual

Product: