593893
2
Zoom out
Zoom in
Previous page
1/2
Next page
HOW TO ENGAGE AND DISENGAGE
THE ALARM AND THE HOURLY TIME
SIGNAL
1 Press Button C in the time/calendar display
to show the alarm display. The alarm display
is shown while Button C is kept pressed.
2 With each press of Button B while keeping
Button C pressed, the engagement and
disengagement of the alarm and the hourly
time signal are made as follows:
Changeover in the alarm display
24-hour
12-hour
[Keeping Button C pressed]
* When the “A” (AM)/“P” (PM) mark disap-
pears, the calendar or the alarm display is
shown in the 24-hour indication.
When EL button is pressed and released in the
time/calendar or stopwatch display, or in the
alarm setting or time/calendar setting function,
the electroluminescent light evenly illuminates
the display for 4 seconds for easy viewing in the
dark.
EL button
Notes:
1. The watch works with one battery. When the
light begins to lose its luminance, this is an
indication that the battery is depleted. We
recommend that you change the battery
before the watch itself stops.
2. If the light is used continuously for a long time,
the battery life may be less than the specified
period.
BATTERY CHANGE
The miniature battery which powers your watch
should last as individually specified below.
However, because it is inserted at the factory,
the actual life of the battery once in your
possession may be less than the specified
period. Be sure to replace the battery to
prevent any possible malfunction as soon as it
runs down. To replace the battery, we
recommend taking the watch to a local watch
repair shop.
EL button
(for Cal. YK32 & Z001 only)
ILLUMINATING LIGHT
(for Cal. YK30, YK31, YK32, YK33,
YK34 & Z001)
BATTERY
LIFE
(Approx.)
CAL. NO.
BATTERY
Note: If the alarm is used for more than 30
seconds a day (and/or the illuminating
light for more than 4 seconds a day for
Cal. YK30, YK31, YK32, YK33, YK34 & Z001),
the battery life may be less than the
specified period.
Z003
SONY CR1020, 1 piece
4 years
SONY CR2032, 1 piece 8 years
Z001
2 years
YK34
YK32
SONY CR1620, 1 piece
SONY CR1220, 1 piece
2 years
YK31
SONY CR2016, 1 piece
YK30
YK33
Z002
Y922
CARE OF YOUR LORUS WATCH
This watch contains precise electronic
components. Never attempt to open the case
or remove the back cover.
BATTERY
CAUTION
Do not expose the old battery to fire or
recharge it. Keep it at a place beyond
the reach of children. If a child swallows
it, consult a doctor immediately.
WATER RESISTANT
* If your watch is 200 M/20 BAR, 100 M/10 BAR
or 50 M/5 BAR water resistant, it is so
indicated on the dial/case back.
Do not operate the buttons when the watch
is wet.
If the watch is exposed to salt water, rinse it
in fresh water and then wipe it thoroughly
dry.
NO NO NO
YES
YES
YES NO NO
YES YES NO
Condition
of use
Accidental
contact
with water,
such as
splashes
and rain
Swimming
and taking
a shower
Skin
diving
Scuba
diving
Indication
on the dial/
case back
No
Indication
NO
NO
NO
YES
WATER
RESISTANT
WATER
RESISTANT
(50M/5 BAR
)
WATER
RESISTANT
100M/10 BAR
or above
(
NO
(
Caution:
Leather straps are not water resistant except so
indicated, even if the watch head is water
resistant.
ALLERGIC REACTION
Because the case and band touch the skin
directly, it is important to clean them regularly.
If not, shirt sleeves may be stained and those
with delicate skin may develop a rash. Please
wear the watch with some play to avoid any
possible allergic reaction. If you develop a rash
on your wrist, stop wearing and consult a
physician.
MAGNETISM
Your watch will be adversely affected by strong
magnetism. Keep it away from close contact
with magnetic objects.
SHOCKS AND VIBRATIONS
Your watch may be worn for normal sports
activities, but be careful not to drop it or hit it
on hard surfaces.
TEMPERATURE
Your watch is preadjusted so that constant
accuracy may be insured a normal
temperature.
SERVICE
When your LORUS watch requires repair or
sevicing, please see the enclosed WARRANTY/
GUARANTEE.
Printed in China
Cal. Y922:
10 years
Z009
Cal. YK30:
2 years
Cal. YK33:
2 years
Cal. Z002:
5 years
Cal. Z009:
2 Years
“A” (AM)
B
C
Hour
Alarm display
Minute
The alarm rings at the designated time for 30
seconds and stops. However, the alarm can be
stopped manually by pressing Button C in any
display.
HOW TO SET THE TIME/CALENDAR
Time/calendar setting indicator
1 Press Button A to activate the time/calendar
setting function. (The time/calendar setting
indicator and the second digits start
flashing.)
2 Selection of the digits to be adjusted (flash-
ing) is made in the following order by pressing
Button B.
3 One digit (flashing) is advanced with each
press of Button C. (The digits except seconds
are advanced quickly by keeping Button C
pressed.)
Second setting
Press Button C in accordance with a time
signal. The seconds are reset to “00” and
start immediately.
When the seconds count any number
from “30” to “59” and Button C is pressed,
one minute is added and the seconds are
immediately reset to “00”.
4 After all the adjustments are completed,
press Button A to return to the time/calendar
display.
Note: When setting the hour digits, be sure to
check that the “A” (AM)/“P” (PM) mark is
correctly set.
Second Minute
MonthHour
Day Date
A
Alarm is engaged.
Hourly time signal is
disengaged.
Alarm and hourly time
signal are disengaged.
Hourly time signal is
engaged.
Alarm is disengaged.
ALARM TEST
The alarm can be tested with a beeping sound
by pressing Buttons B and C at the same time in
the time/calendar display.
B
C
Alarm and hourly time
signal are engaged.
HOW TO STOP THE ALARM
HOW TO CHANGE OVER THE 12-HOUR
AND 24-HOUR INDICATIONS
In the calendar or the alarm display, each press
of Button A changes over the time indication
display from the 12-hour to the 24-hour and vice
versa.
Changeover in the calendar display
24-hour
A
A
12-hour
[Keeping Button B pressed]
A
A
LUMIBRITE WATCH
If your watch is a LORUS LUMIBRITE watch, it
has following features.
LORUS LUMIBRITE watches absorb and store light
energy from natural and artificial light sources
and emit light in the dark. They are made of
environmentally friendly material, and therefore,
are harmless to human beings and the
environment.
With a full charge, LORUS LUMIBRITE watches
glow in the dark hours longer than conven-
tional luminous watches of this type. If ex-
posed to a light of more than 500 lux (i.e.,
the brightness of a typical office) for approxi-
mately 10 minutes, or direct sunlight for 2
minutes, they will glow for hours.
Since LORUS LUMIBRITE watches emit the light
they store, the brightness will decrease
gradually over time. The length of time they
will glow may also differ slightly depending
on such factors as the brightness of and
distance from the light source used to charge
the watch.
BLUE 10.8.18, 5:19 PMPage 2 Adobe
2


Need help? Post your question in this forum.

Forumrules
1

Forum

lorus-z001

Reset search

  • Hi I’m having trouble setting the time on this model watch. How do I do that Submitted on 11-7-2022 at 00:20

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lorus Z001 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lorus Z001 in the language / languages: English as an attachment in your email.

The manual is 0,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Lorus Z001

Lorus Z001 User Manual - German - 2 pages

Lorus Z001 User Manual - Dutch - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info