593904

Lorus YM62 Manual

2
Zoom out
Zoom in
Previous page
1/2
Next page
■ STOPWATCH
■ LUMIBRITE WATCH
✼ If your watch is a LORUS LUMIBRITE watch,
it has following features.
LORUS LUMIBRITE watches absorb and store
light energy from natural and artificial light
sources and emit light in the dark. They are
made of environmentally friendly material,
and therefore, are harmless to human beings
and the environment.
• With a full charge, LORUS LUMIBRITE
watches glow in the dark hours longer than
conventional luminous watches of this type.
If exposed to a light of more than 500 lux
(i.e., the brightness of a typical office) for
approximately 10 minutes, or direct sunlight
for 2 minutes, they will glow for hours.
•Since LORUS LUMIBRITE watches emit the
light they store, the brightness will decrease
gradually over time. The length of time they
will glow may also differ slightly depending
on such factors as the brightness of and
distance from the light source used to
charge the watch.
■ BATTERY CHANGE
The miniature battery SEIKO SR927W, Maxell
SR927W or SONY SR927W or EVEREADY
399,which powers your watch should last
approximately 3 years. However, because it
is inserted at the factory, the actual life of the
battery once in your possession may be less
than 3 years.
Be sure to replace the battery to prevent any
possible malfunction as soon as it runs down.
To replace the battery we recommend taking
the watch to a local watch repair shop.
Notes:
1. If the stopwatch is used for more than 2
hours a day and/or the alarm rings for more
than 20 seconds a day, the battery life may
be less than the specified period.
2. After the battery is replaced with a new
one, set the time/calendar and alarm and
adjust the stopwatch hand position.
■ CARE OF YOUR LORUS WATCH
• BATTERY
CAUTION
Do not expose the old battery to fire
or recharge it. Keep it at a place
beyond the reach of children. If a
child swallows it, consult a doctor
immediately.
• WATER RESISTANT
* If your watch is 200 M/20 BAR, 100 M/10 BAR
or 50 M/5 BAR water resistant, it is so
indicated on the dial/case back.
• Do not operate the buttons when the
watch is wet.
• If the watch is exposed to salt water, rinse
it in fresh water and then wipe it thoroughly
dry.
NO NO NO
YES
YES
YES NO NO
YES YES NO
Condition
of use
Accidental
contact
with water,
such as
splashes
and rain
Swimming
and taking
a shower
Skin
diving
Scuba
diving
Indication
on the dial/
case back
No
Indication
NO
NO
NO
YES
WATER
RESISTANT
WATER
RESISTANT
(50M/5 BAR
)
WATER
RESISTANT
100M/10 BAR
or above
(
NO
(
Caution:
Leather straps are not water resistant except
so indicated, even if the watch head is water
resistant.
• ALLERGIC REACTION
Because the case and band touch the skin
directly, it is important to clean them regularly.
If not, shirt sleeves may be stained and those
with delicate skin may develop a rash. Please
wear the watch with some play to avoid any
possible allergic reaction. If you develop a
rash on your wrist, stop wearing and consult a
physician.
• MAGNETISM
Your watch will not be affected by magnetism
generated by household electric appliances.
•SHOCKS AND VIBRATIONS
Your watch may be worn for normal sports
activities, but be careful not to drop it or hit it
on hard surfaces.
• TEMPERATURE
Your watch is preadjusted so that constant
accuracy may be insured at normal tempera-
ture.
■ SERVICE
When your LORUS watch requires repair or
sevicing, please see the enclosed WARRANTY/
GUARANTEE.
Printed in China
✩ Before using the stopwatch, be sure to
check that the crown is set at the normal
position and that the stopwatch hands are
reset to the “0” position.
* If the hands do not return to the “0” position,
follow the procedure in “■ SETTING THE TIME
AND ADJUSTING THE STOPWATCH HAND
POSITION”.
Stopwatch operation
■ SINGLE-TIME ALARM
• The alarm can be set to ring only once at a
designated time within the coming 12
hours.
• The alarm time can be set in one minute
increments.
✩ Before using the alarm, check that the
alarm hands are adjusted to the current
time. (See “■ SETTING THE TIME AND
ADJUSTING THE STOPWATCH HAND
POSITION”)
1. Pull out the crown to the first click.
2. Press button “B” repeatedly to set the
desired alarm time.
* The hands move quickly if button “B” is kept
pressed.
3. Push the crown back in to the normal
position.
* The alarm is automatically engaged.
Notes:
1. The single-time alarm cannot be set for a
time more than 12 hours ahead of the
current time. While you keep button “B”
pressed to advance the alarm hands
quickly, they stop when they indicate the
current time. In that case, release button
“B”, and then, keep the button pressed
again to set the alarm hands to the desired
time.
2. While the crown is at the normal position,
the alarm hands indicate the current time
when the alarm is disengaged and the
designated alarm time when it is engaged.
• The stopwatch can measure up to 60
minutes in 1/5 second increments.
• After 60 minutes, it will start counting again
from “0” repeatedly up to 12 hours.
Start
Stop
Reset
B
AA
Standard measurement
* Measurement and release of
split time can be repeated by
pressing button “B”.
Start Split
Split
release
Stop Reset
B
A
B
B
A
Split time measurement
B
B
A
B
A
Start
Finish time
of 1st
competitor
2nd
competitor
finishes
Finish time
of 2nd
competitor
Reset
Measurement of two competitors
● The alarm rings at the designated time for
20 seconds, and it is automatically
disengaged as it stops. To stop it manually,
press button “A” or “B”.
* While the stopwatch is measuring, the alarm
rings differently than usual. However, this is
not a malfunction.
* While the alarm is ringing, pressing button “A”
or “B” will only stop the alarm, and no
stopwatch operation can be made.
1. Pull out the crown to the first click, and press
and hold button “B” until the alarm hands
stop to indicate the current time.
2. Push the crown back in to the normal
position.
Note:
To correct the alarm time you have set, follow
the procedure described in “Alarm time
setting”.
To stop the alarm
To cancel the alarm time you have set
Alarm hour
hand
Alarm minute hand
B
A
Alarm time setting
* Restart and stop of the
stopwatch can be repeated
by pressing button “A”.
B
Start
Stop
Restart
Stop
Reset
A
A
A
A
Accumulated elapsed time measurement
Stopwatch 1/5-second
hand
A: Start /
Stop
B: Split /
Split release/
Reset
Stopwatch
minute hand
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lorus YM62 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lorus YM62 in the language / languages: English as an attachment in your email.

The manual is 0,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Lorus YM62

Lorus YM62 User Manual - German - 22 pages

Lorus YM62 User Manual - Dutch - 22 pages

Lorus YM62 User Manual - French - 22 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info