593876

Lorus Y182 Manual

3
Zoom out
Zoom in
Previous page
1/4
Next page
• The stopwatch can measure up to 30 minutes
in 1/5 second increments.
•After 30 minutes, it will start counting again
fron “0” repeatedly up to 6 hours.
■ HOW TO USE THE STOPWATCH
A
Stopwatch 1/5-second hand
■ ADJUSTING THE STOPWATCH HAND
POSITION
•If the stopwatch hands will not return to
the “0” position when the stopwatch is reset
or when the battery is replaced with a new
one, follow the procedure below to reset
the hands.
Stopwatch
minute hand
Stopwatch
1/5-second
hand
1. Pull out Crown 1 to the second click.
2. Press button “A” repeatedly to reset the
stopwatch minute hand to the “0” position.
Press button “B” repeatedly to reset the
stopwatch 1/5-second hand to the “0”
position.
* The hands move quickly if the respective
buttons are kept pressed.
3. Push Crown 1 back in to the normal position.
* After adjusting the hand position, set
the time.
■ RESETTING THE BUIT-IN IC
• In case any of the hands should move improperly,
follow the procedure below to adjust the
hand movement.
B
Stopwatch minute hand
Second click
BA
A
B
Crown 1
Second click
1. Pull out Crown 1 to the second click.
2. Press buttons “A” and “B” simultaneously
3. Push Crown 1 back in to the normal position.
* Before using the watch again, be sure to
adjust the position of the stopwatch hands
and set the time and alarm.
■ LUMIBRITE WATCH
(dial, hands, buttons, case, bezel,
strap, etc.)
✩ If your watch is a LORUS LUMIBRITE watch,
it has following features.
LORUS LUMIBRITE watches absorb and store
light energy from natural and artificial light
sources and emit light in the dark. They are
made of environmentally friendly material,
and therefore, are harmless to human beings
and the environment.
• With a full charge, LORUS LUMIBRITE
watches glow in the dark hours longer than
conventional luminous watches of this type.
If exposed to a light of more than 500 lux
(i.e., the brightness of a typical office) for
approximately 10 minutes, or direct sunlight
for 2 minutes, they will glow for hours.
• Since LORUS LUMIBRITE watches emit
the light they store, the brightness will
decrease gradually over time. The length
of time they will glow may also differ slightly
depending on such factors as the brightness
of and distance from the light source used
to charge the watch.
✩ Before using the stopwatch, be sure to check
that Crowns 1 and 2 are set at the normal
position, and press button “B” to reset the
stopwatch hands to “0” position.
Standard measurement
Stopwatch operation
A
Start Stop Reset
A
Accumulated elapsed time measurement
B
A
Start Stop Restart Stop Reset
A A
B
A
* Restart and stop of stopwatch
can be repeated by pressing
button “A”.
A
Start Split Split Stop Reset
release
A
Split time measurement
BB
B
* Measurement and release of
split time can be repeated by
pressing button “B”.
Measurement of two competitors
A
Start Finish 2nd Finish Reset
time
competitor
time
of 1st
finishes
of 2nd
competitor competiror
BB A B
Notes on crown operation while the
stopwatch is in use:
1. If Crown 1 is pulled out to the second
click, the stopwatch hands are reset to
“0” position.
2. If Crown 2 is pulled out to the first or
second click, the stopwatch hands are
reset to “0” position.
3. When the stopwatch has been reset and
button “A” is pressed before the hands
reach “0” position, the stopwatch still
starts counting when button “A” is pressed.
Crown 1
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lorus Y182 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lorus Y182 in the language / languages: English as an attachment in your email.

The manual is 0,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Lorus Y182

Lorus Y182 User Manual - German - 20 pages

Lorus Y182 User Manual - Dutch - 20 pages

Lorus Y182 User Manual - French - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info