549208
11
Zoom out
Zoom in
Previous page
1/58
Next page
11 -
English
Setting up
Installing the Individual Sound Stand
Speaker SL system
Basic information
CAUTION: THE ALUMINIUM SURFACE OF THE INDIVIDUAL SOUND STAND
SPEAKER SL IS VERY SENSITIVE TO SCRATCHING AND IMPACT. AVOID ALL
CONTACT WITH SHARP OBJECTS. DO NOT PLACE VASES, CANDLES OR OTHER
OBJECTS ON TOP OF THE UNIT.
CAUTION: DO NOT CONNECT THE INDIVIDUAL SOUND STAND SPEAKER SL TO
AN AMPLIFIER OUTPUT, WHICH EMITS FREQUENCIES 150 HZ, IN ORDER TO
AVOID DAMAGING THE LOUDSPEAKER.
Place the speaker on a rm, level base.
Hold the speaker on the sides and base plate when moving it. If the fabric
lining becomes creased when doing so, please smooth this out carefully with
your hand.
Carefully pull the protective lm off the trim on the top.
Please note, that the speakers consist of a right and left unit. A mark is on
the product label at the base of each unit.
Do not place the speakers near to strong sources of heat or in direct sunlight.
Pull out the power adapter during thunderstorms. Surge voltages caused by
lightning strikes can damage the unit.
Also remove the power adapter in long periods of absence.
The power adapter set must be easily accessible so that the unit can be
disconnected from the power supply at all times.
Lay the speaker and power cables in such a way that they cannot be dama-
ged. The power cable may not be kinked or laid over sharp edges, not stood
on and not exposed to chemicals; the latter also applies to the system as a
whole. A power cable with damaged insulation can lead to electric shocks
and is a re risk and must therefore be changed by quali ed service personnel
before operation of the set continues.
Functional principle
The electrostatic speaker element used is an inverse high-voltage unit with
dipole emission and additive treble array, activated by specially adapted high-
voltage electronics.
The ef ciency is twice as high as conventional electrostatic speakers thanks to
the inverse arrangement and activation of the stators and speaker diaphragm.
The surface emission of the sound means the volume heard remains in the
range from 1 to 6 m hearing distance.
The combination of surface emitter and dipole operation comes closest to the
natural sound propagation of the original instruments and sounds.
The natural characteristics of the sounds are retained as far as possible with this
technology.
A widening of the emission angle so as to enable several listeners to enjoy the
sound simultaneously has been achieved by the additional asymmetrical treble
array. The left and right speakers are therefore different.
This innovative acoustic concept has been made possible by the use of new
materials, surface nishing, production processes and electronic circuits.
This technical re nement is devoted solely to the aim of meeting the most
demanding acoustic expectations and reproducing the natural characteristics of
the original sound unobtrusively and appealingly in your living room.
Optimum arrangement
Please note, that due to the the operating principle of the Individual Sound
Stand Speaker SL, the sound is emitted on the front and rear side.
It is useful if the distance from the walls (to the rear as well as left and right) is
about equal, so that the sound distribution into the room may be optimal.
In addition, the sound emission is directional.
It is therefore recommended to arrange the speaker in a way, that they face into
your preferred listening position (page 12).
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Loewe Individual Sound Stand Speaker SL at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Loewe Individual Sound Stand Speaker SL in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 4,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info