475109
18
Zoom out
Zoom in
Previous page
1/164
Next page
Connect ID 32-55 - 18 -
Operating instructions
Connecting the TV Set
Connecting to the mains
Remove the cover for the connections.
Connect the TV set to a 220-240V mains socket:
First plug the small plug of the power cable into the mains connection
on the back of the TV and then the large mains plug into a mains socket.
Connecting antennas
Cable (analogue) / DVB-C / DVB-T antenna:
Plug the antenna cable of antenna, cable system or room antenna into
the ANT TV socket.
If you want to use analogue cables / DVB-C connection and a DVB-T
antenna together, use an external antenna switch (available from your
dealer).
Satellite antenna DVB-S:
If the TV set is equipped with a Single
(1
or Twin
(2
satellite tuner, the ANT-
SAT and ANT-SAT2
(2
sockets are available.
Depending on the used satellite system, connect a connecting cable from
the multi-switch or directly from the LNC to the ANT-SAT and ANT-SAT2
sockets of the TV set respectively.
When connecting the TV set to a single cable community antenna,
connect the ANT-SAT and ANT-SAT2 sockets directly to the appropriate
SAT antenna socket.
When connecting the TV set to a DiSEqC single cable community antenna
(in accordance with EN 50494), connect the ANT-SAT socket directly to
the appropriate SAT antenna socket.
A DiSEqC single cable community antenna is also needed on TV sets
with integrated digital recorder (DR
+
) and therefore two available
satellite sockets (ANT SAT and ANT SAT2). Further distribution of the
signal to the two reception routes is accomplished by the TV set‘s
satellite tuner.
Ask your dealer if required.
R TV
Cable
analogue /
DVB-C
DVB-T DVB-S
Installing the TV set
Mounting options
Your Loewe specialist dealer can assist you in finding other mounting
options that correspond to your needs. Use exclusive Loewe mounting
options (e.g., wall mount, floor stand), which you will find in the chapter
entitled Accessories - Mounting options on page 145.
After you have decided on a mounting option, follow the directions
found in the corresponding assembly instructions.
Installation notes
Choose a place for installing your TV where no bright light or sunlight
shines directly onto the screen. This could cause reflections which
impair the picture.
3 times the screen diagonal can be taken as a guide value for the view-
ing distance (e.g. for 40-inch set approx. 3m for SD signal). The viewing
distance can be reduced with an HD signal.
Set covers
Covers for rear and side connections
To remove the rear cable cover, pull the two recessed handles at the
bottom and drop down the cover.
To fit the cover, insert the lugs at the top edge of the cover into the
corresponding cut-outs in the rear panel and push up the cover until
it snaps in.
The side cover of the TV set can also be completely removed. For this,
open it as far as it will go and gently pull on the open cover.
The cover detaches from the holder and gives free access to the con-
nection area. To replace the cover, simply push it until it latches back
into place.
n
Initial installation
(1
only for TV sets without DR
+
.
(2
only for TV sets with DR
+
.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Loewe Connect ID 40 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Loewe Connect ID 40 in the language / languages: English as an attachment in your email.

The manual is 48,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Loewe Connect ID 40

Loewe Connect ID 40 User Manual - German - 162 pages

Loewe Connect ID 40 User Manual - Dutch - 164 pages

Loewe Connect ID 40 User Manual - French - 52 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info