Manual Load Up 77002 (page 21 of 40) (English, German, Dutch, French)

621656

Zoom out

Zoom in

1/40

Load UP

4.0 GENERAL WARNINGS AND MODE OF EMPLOYMENT

In order not to damage either the battery or the battery charger, it is necessary to

observe the following operating instructions and warnings:

• After removing the machine from its box, make sure that it is complete in all of

its parts.

• Unwind the input cable in its entire length and extend it, so that it cannot be

trampled on or crushed.

• Lengthen the input cable with an extension if necessary, make sure that the

current capacity is the same as that of the original cable; do not use cables

having a smaller section.

• In case the socket and plug are not compatible, use only simple or multiple

adaptors complying with the safety regulations in force and having a proper

capacity.

• The connecting clamps, the charging clips and the upper surface of the battery

must always be clean; eventually clean well the clips of the battery with an iron

brush.

• Never

reverse the polarity of the connections; if in doubt, remember that the

negative clamp (-) is directly connected to the body of the motor vehicle.

• The charging voltage of the battery charger must be equal to the nominal one

indicated on the battery; it coincides with the number of elements of the battery

mulltiplied by two (i.e. 6 elements = 12 V).

• During the operation set the battery charger in a stable position and make sure

that the openings for the passage of air are not obstructed.

• Remove the caps of the battery once the clamps have been cleaned, so that

dust or other particles do not fall into the battery elements, and leave them in

this way for the entire duration of the charge.

• Make sure that the electrolytic liquid covers the plates for at least 4-5 mm; if

necessary add distilled water of the type marketed for this purpose.

Warning: do not

touch the liquid inside the battery; it is corrosive!

• It is advisable to always disconnect the cables connected to the positive pole of

the battery.

• Do not perform the simultaneous charging of several batteries.

• Avoid any attempt of re-charging batteries which cannot be re-charged.

• Keep the battery charger in a dry place.

5.0 DURATION OF THE CHARGING PROCESS

The duration of the charging process always depends on the situation of the

battery to be charged (almost charged, half-way or completely discharged) and on

its conditions.

To "rejuvenate" a battery normally in use, 2 to 4 hours are usually sufficient. For a

complete re-charge 8 to 10 hours may be necessary.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Load Up 77002 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,86 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Load Up 77002 Manual

Product: