Little tikes 657511C3 Real Wood Adventures Glamping House Manual
6
Zoom out
Zoom in
Previous page
1/28
Next page
6
INFORMATION ON PLAYGROUND SURFACING MATERIALS
The following information is from the United States Consumer Product Safety Commission’s Information
Sheet for playground surfacing material. Additional Information can be found here:
https://www.cpsc.gov/s3fs-public/324.pdf
SECTION 4 OF THE CONSUMER PRODUCT SAFETY COMMISSION’S OUTDOOR HOME PLAYGROUND SAFETY HANDBOOK
Select Protective Surfacing
One of the most important things you can do to reduce the likelihood of serious head injuries is to install shock-absorbing protective surfacing
under and around your play equipment. The protective surfacing should be applied to a depth that is suitable for the equipment height in accordance with
ASTM F 1292. There are dierent types of surfacing to choose from; whichever product you select, follow these guidelines:
NOTE: Do not install home playground equipment over concrete, asphalt, or any other hard surface. A fall onto a hard surface can result in serious
injury to the equipment user. Grass and dirt are not considered protective surfacing because wear and environmental factors can reduce their shock
absorbing eectiveness. Carpeting and thin mats are generally not adequate protective surfacing. Ground level equipment such as a sandbox,
activity wall, playhouse or other equipment that has no elevated play surface – does not need any protective surfacing.
Loose-Fill Materials:
• Maintain a minimum depth of 9 inches of loose-ll materials such as wood mulch/chips, engineered wood ber (EWF), or
shredded/recycled rubber mulch for equipment up to 8 feet high; and 9 inches of sand or pea gravel for equipment up to 5 feet high.
NOTE: An initial ll level of 12 inches will compress to about a 9-inch depth of surfacing overtime. The surfacing will also compact,
displace, and settle, and should be periodically relled to maintain at least a 9-inch depth.
• Use a minimum of 6 inches of protective surfacing for play equipment less than 4 feet in height. If maintained properly, this should be
adequate. (At depths less than 6 inches, the protective material is too easily displaced or compacted.)
• Use containment, such as digging out around the perimeter and/or lining the perimeter with landscape edging. Don’t forget to
account for water drainage.
• Check and maintain the depth of the loose-ll surfacing material. To maintain the right amount of loose-ll materials, mark the correct
level on play equipment support posts. That way you can easily see when to replenish and/or redistribute the surfacing.
• Do not install loose-ll surfacing over hard surfaces such as concrete or asphalt.
Poured-In-Place Surfaces or Pre-Manufactured Rubber Tiles
You may be interested in using surfacing other than loose-ll materials – like rubber tiles or poured-in-place surfaces.
• Installations of these surfaces generally require a professional and are not “do-it-yourself” projects.
• Review surface specication before purchasing this type of surfacing. Ask the installer/manufacturer for a report showing that the
product has been tested to the following safety standard: ASTM F 1292 Standard Specication for Impact Attenuation of Surfacing
Materials within the Use Zone of Playground Equipment. This report should show the specic height for which the surface is intended to
protect against serious head injury. This height should be equal to or greater than the fall height – vertical distance between a designated
play surface (elevated surface for standing, sitting, or climbing) and the protective surfacing below – of your play equipment.
• Check the protective surfacing frequently for wear.
Placement:
Proper placement and maintenance of protective surfacing is essential. Be sure to:
• Extend surfacing at least 6 feet from the equipment in all directions.
This information has been extracted from the CPSC publications “Playground Surfacing — Technical Information Guide” and “Handbook for Public Playground Safety.” Copies of these
reports can be obtained by sending a postcard to the: Oce of Public Aairs, U.S. Consumer Product Safety Commission, Washington, D.C., 20207 or call the toll-free hotline:
1-800-638-2772.
51
Step 77:
Place the Tarp (PB01) over the Glamping House Assembly as shown.
Step 78:
Secure the Tarp to the Rail Board (C07) using (3) Screws (C5).
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Little tikes 657511C3 Real Wood Adventures Glamping House at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Little tikes 657511C3 Real Wood Adventures Glamping House in the language / languages: English as an attachment in your email.
The manual is 8.8 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
The manual is sent by email. Check your email
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
