Manual Little tikes 485718 Bounce Castle Slide Into Ballpit (page 3 of 6) (English)

815346

Zoom out

Zoom in

1/6

WARNING: Repair patches must be applied by an adult only. KEEP OUT OF REACH OF CHILDREN.

REPAIR PATCH INSTRUCTION

1. Deate the item, clean the area and allow to dry thoroughly.

2. Cut a portion of the patch to the size needed and round the corners. (See Fig. 1 & 2).

3. Remove the adhesive backing from the patch material, position the patch over the damaged area and smooth out any bubbles.

4. Allow to sit for 30 minutes before re-inating.

• As an outdoor product, the bouncer is subject to wear and

deterioration. Inspect for signs of fabric failure; weak or torn

surfaces must be repaired promptly.

• To keep the product clean: wipe the bouncer or blower using a dry

cloth or a cloth dampened with a neutral, non-ammable, n ontoxic

cleaning and sanitizing solution or pure water.

• Product should never be stored wet. Allow to dry before rolling up.

• Disassemble and dispose of the equipment in such a manner

that no hazardous conditions exist at the time the equipment is

discarded.

• Blower should be returned to a collection center capable of

processing electrical/electronic waste.

Blower must be unplugged before servicing.

• Product should be periodically examined for potentially unsafe

conditions such as damaged cord, plug, housing, or parts, and that

in the event such damage is found, the product should not be used

until properly repaired. If these checks are not carried out, the product

could overturn or otherwise become a hazard.

• The blower does not require any lubrication and has no user

serviceable parts. Do not attempt to service the blower.

• Do not immerse the fan in water. To clean, wipe with a damp cloth.

• Regularly check the intake and output openings and keep free of

dirt, leaves, etc.

• When not in use, store the blower indoors in a dry place.

• Store the blower upright on a stable surface.

• Loosely coil the cord and place it beside the blower.

• When in use, do not place the cord across trac areas, water or

damp areas.

• The blower is a high volume blower, and is capable of moving large

volumes of air very quickly. Place the blower in an area where it will

not draw in dirt or leaves.

• Do not operate any fan with a damaged cord or plug. Discard

fan or return to an authorized service facility for examination

and/or repair.

• Do not run cord under carpeting. Do not cover cord with throw

rugs, runners, or similar coverings. Do not route cord under

furniture or appliances. Arrange cord away from trac area

and where it will not be tripped over.

Repair Patch Instructions WARNING: NOT A TOY. ADULT USE ONLY.

Repair Patch. Keep away from children.

Instructions for

Bouncer Maintenance

Instructions for

Blower Maintenance

Disposal

NOTE: Set up as close to power source as possible. The product

should be periodically examined for potentially unsafe conditions

such as: damaged cord, plug, housing or parts, and that in the

event such damage is found, the product should not be used until

properly repaired. Never leave the blower outside in the rain or

exposed to the elements when not in use. When in use, do not

place the cord across trac areas, water or damp areas. The

blower should be placed on a stable surface and anchored per

product instructions. The power cord of the blower is equipped

with a Ground Faulty Circuit Interrupter (GFCI) plug.

1) Make sure that the blower switch is in the “OFF” position. Plug

the blower into a properly grounded 110-120V GFCI outlet.

2) If the GFCI has been tripped, press the “RESET” button to

restore power to the blower.

3) Set the power switch of the blower to “ON” to inate. After

use, turn the power to “OFF”.

4) To disconnect, have an adult grip it tightly and pull the plug

from wall outlet.

Safety Warnings: ELECTRICAL BLOWER

MODEL W-1.5L

BLOWER SPECIFICATIONS: 115V (AC),

60 Hz, 3.2A, 368W

SPECIFICATIONS MAY CHANGE WITHOUT NOTICE.

DANGER - TO PREVENT ELECTRIC SHOCK, DO NOT

IMMERSE IN WATER. WIPE CLEAN WITH DAMP CLOTH.

WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS

COULD RESULT IN SERIOUS INJURY OR DEATH. ADULT SETUP

AND SUPERVISION REQUIRED.

CAUTION: ELECTRICALLY

OPERATED PRODUCT

DANGER

WARNING:

Failure to follow these instructions could

result in serious injury or death.

• Cautionary statements which should be read before beginning

assembly.

• ADULT SET-UP AND SUPERVISION REQUIRED.

• Use only with Ground Fault Circuit Interrupt (GFCI) receptacle.

• This blower is for residential use only. It is not intended to be used

in commercial or industrial settings.

• Never insert ngers, pencils or any other object through the grill at

ANY time.

• Do not operate blower with a damaged cord or plug, after the

appliance malfunctions or has been dropped or damaged in any manner.

• Do not operate in the presence of explosive and/or ammable fumes.

• Never connect the blower to any solid - state speed control device.

• To reduce the risk of re or electric shock, do not use this blower

with any solid-state speed control device.

• Always unplug the blower before servicing.

• Outdoor use only.

CAUTION: The blower is a high volume blower, and is capable of moving lots of air very quickly. Place the blower in

an area where it will not suck in dirt or leaves. Keep away from water and trac. Keep children away from the blower.

Only the blower supplied should be used for ination.

INSTRUCTIONS FOR BLOWER INSTALLATION

INSTRUCTIONS FOR BLOWER CLEANING AND STORAGE

Do not immerse the blower in water. Unplug the blower before cleaning. To clean: wipe with a damp cloth. The blower does not require

any lubrication and has no user serviceable parts. Do not attempt to service the blower. When not in use, store the blower indoors in a

dry place. Store the blower upright on a stable surface. Loosely coil the cord and place it beside the blower.

This product should be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by

providing an escape wire for the electric circuit. This product is equipped with a cord having a grounding wire with an ap -

propriate grounding plug. This plug must be plugged into an outlet that is properly installed and grounded in accordance with

all local codes and ordinances. DANGER - Improper installation of the grounding plug can result in a risk of electric shock.

If repair or replacement of the cord or plug is necessary, do not connect the grounding wire to either at blade terminal. The

wire with insulation having an outer surface that is green, with or without yellow stripes, is the grounding wire. Check with a

qualied electrician or serviceman if the grounding instructions are not completely understood, or if in doubt as to whether

the product is properly grounded. Do not modify the plug provided; if it will not t the outlet, have the proper outlet installed

by a qualied electrician. For a grounded, cord-connected product, rated less than 15 amperes and intended for use on a

nominal 110-120-volt supply circuit, these instructions should be followed. This product is for use on a nominal 110-120-

volt supply circuit, and has a grounding plug that looks like the plug illustrated in sketch A. Temporary adapters should not

be used. Do not use product until a properly grounded outlet (sketch A) can be installed by a qualied electrician.

GROUNDING INSTRUCTIONS FOR ALL GROUNDED, CORD-CONNECTED PRODUCTS

This blower is not a toy. Use under the direct supervision of a competent adult. Keep away from children.

READ AND SAVE THESE INSTRUCTIONS.

LISTED

E230679

USE ONLY ON GFCI PROTECTED RECEPTACLES CAUTION

TESE

GROUNDING METHODS

Grounding

WARNING

Electrocution Hazard- DO NOT USE

EXTENSION CORDS WITH THIS PRODUCT.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Little tikes 485718 Bounce Castle Slide Into Ballpit in the language / languages: English as an attachment in your email.

The manual is 2.02 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Little tikes 485718 Bounce Castle Slide Into Ballpit Manual

Product: