815022
3
Zoom out
Zoom in
Previous page
1/6
Next page
WARNING: Repair patched must be applied by an adult only. KEEP OUT OF REACH OF CHILDREN.
REPAIR PATCH INSTRUCTION
1. Deate the item, clean the area and allow to dry thoroughly.
2. Cut a portion of the patch to the size needed and round the corners. (See Fig. 1 & 2).
3. Remove the adhesive backing from the patch material, position the patch over the damaged area and smooth out any bubbles.
4. Allow to sit for 30 minutes before re-inating.
29
Safety Warnings: ELECTRICAL BLOWER
GROUNDING METHODS
Grounding
pin
US
LISTED
E230679
DANGER
Instructions for
Bouncer Maintenance
Instructions for
Blower Maintenance
Disposal
Repair Patch Instructions
WARNING
Electrocution Hazard- DO NOT USE
EXTENSION CORDS WITH THIS PRODUCT.
As an outdoor product, the bouncer is subject to wear and
deterioration. Inspect for signs of fabric failure; weak or torn
surfaces must be repaired promptly.
To keep the product clean: wipe the bouncer or blower using a
dry cloth or a cloth dampened with a neutral, non-ammable,
non-toxic cleaning and sanitizing solution or pure water.
Product should never be stored wet. Allow to dry before rolling up.
Disassemble and dispose of the equipment in such a manner
that no hazardous conditions at the time equipment is
discarded.
Blower should be returned to a collection center capable of
processing electrical/electronic waste.
Blower must be unplugged before servicing.
Product should be periodically examined for potentially unsafe
conditions such as damaged cord, plug, housing, or parts, and
that in the event such damage is found, the product should not
be used until properly repaired. If these checks are not carried
out, the product could overturn or otherwise become a hazard.
The blower does not require any lubrication and has no user
serviceable parts. Do not attempt to service the blower.
Do not immerse the fan in water. To clean, wipe with a damp
cloth.
Regularly check the intake and output openings and keep free of
dirt, leaves, etc.
When not in use, store the blower indoors in a dry place.
Store the blower upright on a stable surface.
Loosely coil the cord and place it beside the blower.
When in use, do not place the cord across trac areas, water or
damp areas.
The blower is a high volume blower, and is capable of moving
large volumes of air very quickly. Place the blower in an area
where it will not draw in dirt or leaves.
Do not operate any fan with a damaged cord or plug. Discard fan
or return to an authorized service facility for examination and/or
repair.
Do not run cord under carpeting. Do not cover cord with throw
rugs, runners, or similar coverings. Do not route cord under
furniture or appliances. Arrange cord away from trac area and
where it will not be tripped over.
WARNING: NOT A TOY. ADULT USE ONLY.
Repair Patch. Keep away from children.
INSTRUCTIONS FOR BLOWER CLEANING AND STORAGE
Do not immerse the blower in water. Unplug the blower before cleaning. To clean: wipe with a damp cloth. The blower does not require
any lubrication and has no user serviceable parts. Do not attempt to service the blower. When not in use, store the blower indoors in a dry
place. Store the blower upright on a stable surface. Loosely coil the cord and place it beside the blower.
INSTRUCTIONS FOR BLOWER INSTALLATION
NOTE: Set up as close to power source as possible. The product
should be periodically examined for potentially unsafe conditions
such as: damaged cord, plug, housing or parts, and that in the
event such damage is found, the product should not be used until
properly repaired. Never leave the blower outside in the rain or
exposed to the elements when not in use. When in use, do not
place the cord across trac areas, water or damp areas. The blower
should be placed on a stable surface and anchored per product
instructions. The power cord of the blower is equipped with a
Ground Faulty Circuit Interrupter (GFCI) plug.
1) Make sure that the blower switch is in the “OFF” position. Plug
the blower into a properly grounded 110-120V GFCI outlet.
2) If the GFCI has been tripped. press the “RESET button to restore
power to the blower.
3) Set the power switch of the blower to ON” to inate. After use,
turn the power to “OFF”.
4) To disconnect, have an adult grip it tightly and pull the plug
from the wall outlet.
CAUTION: The blower is a high volume blower, and is capable of moving lots of air very quickly.
Place the blower in an area where it will not suck in dirt or leaves. Keep away from water and trac.
Keep children away from the blower. Only the blower supplied should be used for ination.
CAUTION: ELECTRICALLY
OPERATED PRODUCT
DANGER - TO PREVENT ELECTRIC SHOCK, DO NOT IMMERSE
IN WATER. WIPE CLEAN WITH A DAMP CLOTH.
WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS COULD
RESULT IN SERIOUS INJURY OR DEATH. ADULT SET-UP AND
SUPERVISION REQUIRED.
Cautionary statements which should be read before beginning
assembly.
ADULT SET-UP AND SUPERVISION REQUIRED.
Use only with Ground Fault Circuit Interrupt (GFCI) receptacle.
This blower is for residential use only. It is not intended to be used in
commercial or industrial settings.
Never insert ngers, pencils or any other object through the grill at
ANY time.
Do not operate blower with a damaged cord or plug, after the
appliance malfunctions or has been dropped or damaged in any
manner.
Do not operate in the presence of explosive and/or ammable
fumes.
Never connect the blower to any solid - state speed control device.
To reduce the risk of re or electric shock, do not use this blower
with any solid-state speed control device.
Always unplug the blower before servicing.
Outdoor use only.
WARNING: Failure to follow these instructions
could result in serious injury or death.
This blower is not a toy. Use under the direct supervision of a competent adult. Keep away from children.
READ AND SAVE THESE INSTRUCTIONS.
USE ONLY ON GFCI PROTECTED RECEPTACLES
GROUNDING INSTRUCTIONS FOR ALL GROUNDED, CORD-CONNECTED PRODUCTS
This product should be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock
by providing an escape wire for the electrical circuit. This product is equipped with a cord having a grounding wire with
an appropriate grounding plug. DANGER - Improper installation of the grounding plug can result in a risk of electric
shock. If repair or replacement of the cord or plug is necessary, do not connect the grounding wire to either at blade
terminal. The wire with insulation having an outer surface that is green, with or without yellow stripes, is the grounding
wire. Check with a qualied electrician or serviceman if the grounding instructions are not completely understood, or if in
doubt as to whether the product is properly grounded. Do not modify the plug provided; if it will not t the outlet, have
the proper outlet installed by a qualied electrician. For a grounded, cord-connected product, rated less than 15 amperes
and intended for use on a nominal 110-120 volt supply circuit, these instructions should be followed. This product is for
use on a nominal 110-120 volt supply circuit, and has a grounding plug that looks like the plug illustrated in sketch A.
Temporary adapters should not be used. Do not use product until a properly grounded outlet (sketch A) can be installed
by a qualied electrician.
CAUTION
1 2
The product should be periodically examined for potentially unsafe
conditions such as: damaged cord, plug, housing, or parts, and that
in the event such damage is found, the product should not be used
until properly repaired. Never leave the fan outside in the rain or
elements when not in use. Minor repairs can be made using the
enclosed repair patches.
MODEL RW-1L
BLOWER SPECIFICATIONS: 115V (AC),
60 HZ, 2.8A, 322W
SPECIFICATIONS MAY CHANGE WITHOUT NOTICE.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Little tikes 485053 Dunk n Toss Bouncer at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Little tikes 485053 Dunk n Toss Bouncer in the language / languages: English as an attachment in your email.

The manual is 0.49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info