612980
4
Zoom out
Zoom in
Previous page
1/41
Next page
Chapter 1
Product Overview
1
Wireless-N Access Point with Dual-Band
Chapter 1:
Product Overview
Thank you for choosing the Linksys by Cisco
Wireless-N Access Point with Dual-Band. The Wireless-N
Access Point with Dual-Band adds wireless capability to
your existing wired network, or upgrades older wireless
networks to Wireless-N performance. For first-time
installation, run the Setup Wizard on the enclosed CD.
To configure advanced settings, use the convenient,
browser-based utility.
LEDs Panel
Wireless (Blue) The Wireless LED lights up
when there is a wireless connection. The LED
flashes when the Access Point is actively sending
or receiving data over the wireless network.
Wi-Fi Protected Setup™ Button If you have
client devices, such as wireless adapters, that
support Wi-Fi Protected Setup™, then you can
use Wi-Fi Protected Setup™ to automatically
configure wireless security for your wireless
network. To use Wi-Fi Protected Setup™, run
the Setup Wizard, or refer to “Wireless > Basic
Wireless Settings” on page 4.
Wi-Fi Protected Setup™ LED (Blue/Amber)
The LED flashes blue for two minutes during
Wi-Fi Protected Setup™. It lights up blue when
wireless security is enabled. If there is an error
during the Wi-Fi Protected Setup™ process,
then the LED lights up amber. Make sure the
client device supports Wi-Fi Protected Setup™.
Wait until the LED is off, and then try again.
Ethernet (Blue) The Ethernet LED lights up
when there is a wired connection. The LED
flashes when the Access Point is actively sending
or receiving data over the Ethernet port.
Power (Blue) The Power LED lights up when
the Access Point is powered on.
Ports Panel
Ethernet The Ethernet port connects the
Access Point to a router.
Reset There are two ways to reset the Access
Points factory defaults. Either press and
hold the Reset button for approximately five
seconds, or restore the defaults from the
Administration > Factory Defaults screen in the
Access Point’s browser-based utility.
Power The Power port connects the Access
Point to the included power adapter.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Linksys WAP610N at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Linksys WAP610N in the language / languages: English as an attachment in your email.

The manual is 1,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info