612962
11
Zoom out
Zoom in
Previous page
1/31
Next page
Appendix B
Configuration
10
USB Ethernet Adapter
Appendix B:
Configuring the Adapter
for Use with Nintendo Wii
This chapter describes how to connect and configure the
Adapter for use with Nintendo Wii.
NOTE: Throughout this user guide, it is assumed
that “D” is the letter of your CD-ROM drive.
Connect the USB Ethernet Adapter to one of the 1.
available USB ports on the back of the Nintendo Wii.
Connect one end of the Ethernet cable to the RJ-45 2.
port on the Adapter.
Connect the other end of the Ethernet cable to an 3.
available RJ-45 port on your router or switch.
Power on your Nintendo Wii by pressing the power 4.
button on the front panel of the Wii.
Press 5. A on your Wii Remote to continue through the
Health and Safety Warning Screen.
Starting on the Wii Menu, navigate to the 6. Wii button
(Wii Options) and press A on the Wii remote to confirm
the selection.
Navigate to the 7. Wii Settings button and press A on
the Wii remote.
Navigate to the Right Arrow on page 1 of the 8. Wii System
Settings and press A on the Wii remote to proceed to
page 2 of the Wii System Settings.
Navigate to the 9. Internet button and press A on your
Wii Remote.
Navigate to the 10. Connection Settings button and
press A on your Wii Remote.
Navigate to the connection which shows “Wired” 11.
in the list. If none of the connection options show a
wired connection then you can create one by selecting
Connection 1.
Select 12. Connection Test by navigating to the button
and pressing A.
Navigate to the 13. OK button on the Connection test
to start the network connection. You should see a
message that says Testing Connection”.
If the network test was successful, the message 14.
The connection test was successful” will appear. If a
connection test failure message appears instead, make
sure that the Adapter is connected properly to your
Nintendo Wii and that all wired network connections
are properly connected to your network.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Linksys USB300M at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Linksys USB300M in the language / languages: English as an attachment in your email.

The manual is 1,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info